Nutek ATJG Transmitter User Manual 128 8858 09XR1Pr p65

Nutek Corporation Transmitter 128 8858 09XR1Pr p65

User Manual

128-88581 of 4This transmitter is designed for use with your upgraderemote start unit and is programmed by using the remotestart's program switch in combination with the transmitterbutton. This transmitter can be used with any Audiovox unitcolor coded with an Orange LED in the receiver.To program this transmitter into your remote start upgradeunit:1) Turn the ignition to the on position.2) Press and release the programming switch 3 times.3) Press and hold, for 3 seconds, the button of the transmit-ter you wish to add until the parking light flashes indicatingthe transmitter has been learned.4) Repeat step 3 for each transmitter up to a total of 4.Turn the ignition off to exit the program mode.NOTE: Do not allow more than 15 seconds to lapse betweensteps or the program mode will be automatically exited andyou will have to start over.If you notice decreased operating range or if the LED fails tolight when activating the unit, the batteries will need replace-ment.Model 09XR1PR1
128-88582 of 4Battery ReplacementAfter removing the two #0 pointphillips screws shown, pry apartcase with the edge of a finger nailor a small common screwdriver.Keep hold of the metal key ringloop to prevent its loss as it willseparate from the transmittercase.Carefully remove thedischarged battery by sliding itout from under the clip in thedirection indicated by the arrow inthe diagram. Properly dispose ofthe exhausted battery and inserta new CR2032 battery, takingcare to arrange it so that the + isfacing up toward the + symbol onthe battery clip. Reassemble inthe reverse of above.This device complies with FCC Rules Part 15 Operation andis subject to the following two conditions:(1) This device may not cause harmful interference and(2) This device must accept any interference that may bereceived, including interference that may cause undesiredoperation.NOTE: The manufacturer is not responsible for any radio orTV interference caused by unauthorized modifications tothis equipment. Such modifications could void the user’sauthority to operate the equipment.2
128-88583 of 4Attention: Transmitter Ordering Dep artmentImportant: To help us expedite your order, please print allof the information legibly and mail this form and your pay-ment according to the instructions below.1) Name:_____________________________________2) Address:_________________________________________3) City:________________State:________Zip Code:__________4) Telephone Number: ( )_____________________5) Total Number Of Transmitters Required:_______Cost Per Transmitter is: $65.00Multiply By Number Of Transmitters X6) Enter Total Amount Enclosed: _______(New York State Residents must include the appropriate sales tax)7) Method of Payment: Mastercard Visa Check or Money Order (do not send cash)Make Checks Payable To Audiovox CorporationCredit Card Number:___________________________________Credit Card Expiration Date: ____/___/____8) Mail this form along with your payment to:Transmitter Ordering Dep artmentAudiovox Corporation 150 Marcus Blvd., Haupp auge N.Y.11788Credit card purchasers can order additional or replacementtransmitters by phone. Simply dial 1 - 800 - 645 - 4994, andfollow the instructions from the operator interface.ORDER FORMFOR TRANSMITTER 09XR1Pr3
128-88584 of 4© 2010 Audiovox Electronics Corp., Hauppauge, N.Y. 11788 128-8858

Navigation menu