Nutek ATRFD ALARM DEVICE User Manual NE07 usermaunal

Nutek Corporation ALARM DEVICE NE07 usermaunal

Users Manual

USER MANUAL
NUTEK CORPORATION
Model:NE07
FCC ID:ELVATRFD
Remote Control Transmitters
TRANSMITTER PROGRAMMING
If the need arises for programming of additional or replacement
transmitters,
simply follow the 4 steps outlined below:
1. Turn the ignition to the ON position
2. Press and release the programming button 3 times
3. Press and hold, for 3 seconds, the button of the transmitter you wish
to add until the parking light flashes indicating the transmitter has
been learned
NOTE: Do not allow more than 5 seconds the lapse
between steps or the program mode will be automatically
exited and you will have to start over.
NOTE : The manufacturer is not responsible for any radio or TV interference caused by unauthorized
modifications to this equipment. Such modifications could void the user`s authority to operate the
equipment.
FCC Caution :To assure continued compliance, any changes or modifications not expressly approved
by the party responsible for compliance could void the user's authority to operate this equipment.
(Example - use only shielded interface cables when connecting to computer or peripheral devices).
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and (2) This device must accept any interference
received, including interference that may cause undesired operation.

Navigation menu