OKAYO Electronics TX701 Plug-in UHF Wireless Audio Link Transmitter Module User Manual TX 701
OKAYO Electronics Co., Ltd. Plug-in UHF Wireless Audio Link Transmitter Module TX 701
Contents
- 1. User Manual
- 2. Users Manual
Users Manual
USER'S GUIDE
Plug-In UHF Wireless Audio-Link
Transmitter Module
Notice : The changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority to
operate the equipment.
IMPORTANT NOTE: To comply with the FCC RF exposure
compliance requirements, no change to the antenna or the device is
permitted. Any change to the antenna or the device could result in the
device exceeding the RF exposure requirements and void user’s
authority to operate the device.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Operating Manual for Transmitter Module TX-701
Simple Introduction
Thank you for purchasing this plug-in UHF wireless Audio-Link
transmitter module TX-701. With up to 96 preprogrammed selectable
frequencies, this module could perfectly perform without any external
disturbance. Besides, with LCD display, this module could be operated
and used easily. This manual includes the complete functions and
operations of the wireless transmitter module. Please read this manual
carefully in order to operate and use this system to its fullest potential.
-1-
Description of Functions
Installation and Operation
-2-
1. LCD display
2.TX audio indicator
3. Low audio level indicator
4. High audio level indicator
5. Setting enter
6. Up/ Down selector
7. Power switch and volume control
8. Charging LED for PA system
9. Power switch for PA system
(2)
(1)
(3)
(4)
(5) (8) (9)(6) (7)
a. Turn the power switch (7) clockwise to turn on the
transmitter.
b. The LCD display (1) will show On and then the channel
used before turning off last time.
c. To select the channel, press the set button (5) and the
channel in LCD flash. Press up or down button (6) to
select the channel to transmit, and then press set button
again to enter the setting.
Don't leave transmitter or receiver in hot sun, on a radiator, or
near other sources of high temperature.
Avoid Excessive Heat
Transmitter and receiver may be damaged if dropped.
Avoid Rough Handling
Maintenance
-3-
d. Turn the volume control (7) to the proper position.
e. When transmitting the signals, the TX indicator (2) will light
Green to show the transmitting condition. The AF Level
indicator lights Yellow (3) to show the low audio, lights Red
(4)to show the high audio.
