OKAYO Electronics WT480T-EJ8LT Wireless Microphone User Manual
OKAYO Electronics Co., Ltd. Wireless Microphone
User Manual
User's Guide UHF-PLL TRANSLATION TOUR-GUIDE SYSTEM *** CONTENTS *** A. Descriptions of Parts 3~4 B. Features 5~6 C. Transmitter D. Key Specifications /Special Features Overall system E. Receiver F. Applications 8~11 * * * * * * * * * * * * * -2- A. Descriptions of Parts -3- Antenna MIC. input Power switch LED indicator MIC. volume Battery cover Charging contact CHANNEL SELECT _ UM-3"AA".5V + + UM-3"AA".5V _ OPEN (1) (2) (3) (4) (5) (6) (7) Transmitter (8) Battery box (9) Channel selector (10) Belt clip 2 -4- Antenna EAR. input Power switch LED indicator EAR. volume Battery cover Charging contact CHANNEL SELECT _ UM-3"AA".5V + + UM-3"AA".5V _ OPEN (1) (2) (3) (4) (5) (6) (7) Receiver (8) Battery box (9) Channel selector (10) Belt clip B. Features 1.Transmitter with built-in, hidden electrical condenser mic. volume adjustable , applicable with tie clip or head set microphone. 2.Receiver with built-in ,hidden super thin speaker , volume adjustable , applicable with ear set. 3.Match with dual slots charging stand or 30 slots portable charging case , easy to recharge battery, no need to buy additional batteries. 4.Applicable Occasions : Tour Guide , Museum and Factory visit, Oral multi-languages translating system ,audio-visual language teaching , assist wireless amplification system etc, -5- C. Transmitter R F output 10 mW (according to regulation) Battery life Ni-MH. Rechargeable 10 hours typical Battery life Alkaline disposable 17 hours typical Dimensions (L*W*H) 92*65*25 mm Weight with battery 128g D. Receiver Audio level 0 dBv Earphone connector 3.5mm jack socket, for mono (built-in hidden speaker) or stereo without speaker Battery life Ni- MH. Rechargeable Battery life Alkaline disposable 9 hours typical 16 hours typical Dimensions (D*W*H) 92 * 65 * 2 5 mm Weight 130g -6- E. Key Specifications /Special Features Overall system Oscillation type PLL synthesized control OSC Carrier frequency range UHF 740~865 MHz (according to regulation) Adjustable frequencies pre-programmed 8 or 16 switchable frequencies Battery 1.2V (Ni-mh.1300mA)* 2 AA rechargeable battery 1.5V * 2 AA Alkaline disposable Operating range 70~100M (opening field) -7- F. Applications 1.Before use,please install the antenna and batteries on transmitter and receiver . 2.Transmitter with built-in condenser mini mic. or external microphone (Mic. jack). Receiver with built-in mini spenker or external earphone (earphone jack). 3.Move the power switch of transmitter to the "On" position .The indicator lamp will flash red once indicating power input properly. If the indicator lamp stays red while the switch is on . it means the power of batteries is low and the batteries need to be recharged (when using with rechargeable battery) or to be replaced (with dry cell batteries). 4.Move the power switch of receiver to the "On" position.The green LED will light up indicates receiving the signal from transmitter. When LED stays red while switch is on, it means the power of batteries is low. 5.Adjust the volume control switch both on receiver and transmitter to proper volume. -8- 6.Adjust both transmitter and receiver channel (on back side) to the desired same channel (0~F ch.). If the selected channel is noisy, Adjust them to the other channel. 7.please keep the operntion distance more than 10~20M. between transmitter and receiver when using with multi channel at same time to avoid interference. 8.Please remove the batteries if the units will be out of service for a long time, to avoid possible damage due to leakage. 9.When recharging the transmitter and receiver with charging stand ,please turn the switch to "OFF" position and then insert in the charging slot for recharging.(please use 2 pcs AA size Ni-MH. Rechargeable battery) 10.This system also could use AA type dry battery, but please do not put them on charging stand for recharging. -9- Attention: 1. Keep away from rain , water or the moisture places to avoid any damages caused. 2. Avoid and exteranl forces or impact. 3. Do not use it in high-temperature environment. 4. Do not connect with others different specific power supply. 5. Keep the wireless microphone away from sources of interference such as operating COMPUTERS , VCD , DVD...ect or communication equipment. 6. If the unit is not using for long period , please make sure the batteries are moved out. Notice : The changes or modifications not expressly aproved by the party responsible for compliance could voide the user's authority to operate the equipment. Model FCC ID THIS DEVICE COMPLIES WITH PART 15 OF THE FCCRULES OPERATIONS IS SUBJECT TO THE FOLLOWING TWO CONDITIONS : (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFEERENCE THAT MAY CAUSE UNDESRIED OPERATION -10- built-in earphone (RX) built-in microphone (TX) Audio Volume Fig(1) -11- (TX - RX) TX RX Fig(2) (TX - Multi Rx) RX.1 RX.2 TX RX.3 Fig(3) -12-
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.2 Linearized : No Page Count : 12 Create Date : 2003:08:07 09:18:20 Modify Date : 2003:08:07 09:18:20 Producer : Corel PDF Engine Version 9.397 Author : mo02 Creator : CorelDRAW Version 9.397 Title : WT-480T,480R ^¤å»¡©ú®ÑEXIF Metadata provided by EXIF.tools