OM Digital Solutions WP5 Wireless LAN Module User Manual S044WIFI PCA module Setup 20130422 2

Download:
Mirror Download [FCC.gov]
Document ID	1961562
Application ID	HJKkwjDI9sQ401LtlUr9bw==
Document Description	(Short-term Confidential) User Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	86.25kB (1078175 bits)
Date Submitted	2013-05-09 00:00:00
Date Available	2013-11-05 00:00:00
Creation Date	2017-10-27 13:37:00
Producing Software	GPL Ghostscript 9.18
Document Lastmod	2017-10-27 13:37:00
Document Title	S044WIFI-PCA_module_Setup_20130422-2.pdf
Document Creator	PDFCreator Version 1.0.1
Document Author:	19801

For OEM integration only – device cannot be sold to general public.
Therefore we will not supply the User’s manual, the installation manual is the official for OEM.
S044WIFI-PCA Module
2 䠊Requirement to an Equipment (Camera) containing this module and its instruction manual for FCC and IC
1) The following sentence should be displayed on the equipment containing this module.
"Contains Transmitter Module FCC ID: YSKWP5" or "Contains FCC ID: YSKWP5"
"Contains Transmitter Module IC: 4763E-WP5" or "Contains IC: 4763E-WP5"
2) Industry Canada ICES-003 Compliance Label should be affixed on the equipment or instruction manual.
Industry Canada ICES-003 Compliance Label:: CAN ICES-3 (B)/NMB-3(B)
3) The all following sentences should be written on an instruction manual of the equipment.
FCC CAUTION
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.
This device complies with Part 15 of FCC Rules and Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of this device.
Le présent appareil est conforme aux la partie 15 des règles de la FCC et CNR d'Industrie Canada
applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage
energy radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled environment
and meets the FCC radio frequency (RF) Exposure Guidelines in Supplement C to OET65 and RSS-102 of
the IC radio frequency (RF) Exposure rules. This equipment has very low levels of RF energy that are deemed
to comply without testing of specific absorption ratio (SAR).
Cet équipement est conforme aux limites d’exposition aux rayonnements énoncées pour un environnement
non contrôlé et respecte les règles les radioélectriques (RF) de la FCC lignes directrices d'exposition dans le
Supplément C à OET65 et d’exposition aux fréquences radioélectriques (RF) CNR-102 de l’IC. Cet équipement
émet une énergie RF très faible qui est considérée conforme sans évaluation du débit d’absorption spécifique (DAS).
㻞

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : Yes
Encryption                      : Standard V4.4 (128-bit)
User Access                     : Print, Extract, Print high-res
Author                          : 19801
Create Date                     : 2013:04:22 11:39:37+09:00
Modify Date                     : 2013:05:09 14:25:24+09:00
Subject                         : 
Has XFA                         : No
XMP Toolkit                     : Adobe XMP Core 5.2-c001 63.139439, 2010/09/27-13:37:26
Format                          : application/pdf
Creator                         : 19801
Description                     : 
Title                           : S044WIFI-PCA_module_Setup_20130422-2.pdf
Creator Tool                    : PDFCreator Version 1.0.1
Metadata Date                   : 2013:05:09 14:25:24+09:00
Keywords                        : 
Producer                        : GPL Ghostscript 8.71
Document ID                     : uuid:380d21f5-db36-4f2f-a86c-c10277faf4d2
Instance ID                     : uuid:296f783d-5536-4c91-8303-c4262b8513a2
Page Count                      : 1

EXIF Metadata provided by EXIF.tools