ORION ELECTRIC M115A BLUETOOTH MODULE User Manual Installation manual

ORION ELECTRIC CO., LTD. BLUETOOTH MODULE Installation manual

Contents

Installation manual

Download: ORION ELECTRIC M115A BLUETOOTH MODULE User Manual Installation manual
Mirror Download [FCC.gov]ORION ELECTRIC M115A BLUETOOTH MODULE User Manual Installation manual
Document ID1744576
Application IDaDV+zGYuwRq2i0nhbYQ+XQ==
Document DescriptionInstallation manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize17.6kB (219965 bits)
Date Submitted2012-07-16 00:00:00
Date Available2012-07-17 00:00:00
Creation Date2012-07-04 09:37:56
Producing SoftwareAcrobat Distiller 5.0 (Windows)
Document Lastmod2012-07-04 09:37:56
Document TitleInstallation manual

Assembly instructions
(1/2)
1. Put on a frame.
2. Fix bluetooth module by 2 screws.
Screw
Bluetooth module
OBT-01
Frame
Information to the user.
(2/2)
Indicate "Contains FCC ID: A7RM115A" and "Contains IC: 10291A-M115A" to the host device installed.
Discribe the following sentence to a user's manual of the host device.
FCC CAUTION
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of FCC Rules and Industry Canada licence-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept
any interference, including interference that may cause undesired operation of this device.
Le présent appareil est conforme aux la partie 15 des règles de la FCC et CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit
pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si
le brouillage est susceptible d'en compromettre le fonctionnement.
This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.
This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled environment and meets
the FCC radio frequency (RF) Exposure Guidelines in Supplement C to OET65 and RSS-102 of the IC radio
frequency (RF) Exposure rules. This equipment has very low levels of RF energy that it deemed to comply without
maximum permissive exposure evaluation (MPE). But it is desirable that it should be installed and operated keeping
the radiator at least 20cm or more away from person’s body (excluding extremities: hands, wrists, feet and ankles).
Cet équipement est conforme aux limites d’exposition aux rayonnements énoncées pour un environnement non
contrôlé et respecte les règles les radioélectriques (RF) de la FCC lignes directrices d'exposition dans le
Supplément C à OET65 et d’exposition aux fréquences radioélectriques (RF) CNR-102 de l’IC. Cet équipement
émet une énergie RF très faible qui est considérée conforme sans évaluation de l’exposition maximale autorisée.
Cependant, cet équipement doit être installé et utilisé en gardant une distance de 20 cm ou plus entre le dispositif
rayonnant et le corps (à l’exception des extrémités : mains, poignets, pieds et chevilles).

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.3
Linearized                      : Yes
Create Date                     : 2012:07:04 09:37:56+09:00
Modify Date                     : 2012:07:04 09:37:56+09:00
Page Count                      : 2
Creation Date                   : 2012:07:04 00:37:56Z
Mod Date                        : 2012:07:04 00:37:56Z
Producer                        : Acrobat Distiller 5.0 (Windows)
Metadata Date                   : 2012:07:04 00:37:56Z
EXIF Metadata provided by EXIF.tools
FCC ID Filing: A7RM115A

Navigation menu