Omron Automotive Electronics Korea OKA-870R RF Keyless Entry System (Receiver) User Manual Table of contents

Omron Automotive Electronics Korea Co., Ltd. RF Keyless Entry System (Receiver) Table of contents

User Manual

OMRON AUTOMOTIVE ELECTRONICS KOREA OKA- 870R Transmitter, RF Keyless Entry System
1. Constitution of the Radio Frequency Keyless Entry System for vehicle The radio frequency keyless entry is a system that it controls locking and unlocking the door and the trunk and the panic by wireless remote controller. This system consists of three components. The TRANSMITTER is a device that transmits the signal when the button is pressed. The transmission signal consists of several synchronous codes, unique identification code, security code and function code and crc code. The RECEIVER is fixed inside the vehicle. It works intermittently to prevent the battery exhaustion. When the receiver detects the synchronous code, it runs continuously to receive the signals completely. After receiving the signal, the receiver decides which operation will be performed. The user can select the following operations by pressing the button of the remote transmitter. OPERATION ACTION LOCK lock the door UNLOCK unlock the door TRUNK open the trunk PANIC alarm the horn Transmitter f = 313.85MHz - 1 -
2. User's manual (provisionally) REMOTE TRANSMITTER You can lock and unlock your vehicle with the remote transmitter. LOCK When you push the LOCK button, all the doors will lock. You cannot lock any of the doors with the remote transmitter if the key is the ignition switch. UNLOCK When you push the UNLOCK button, all the doors will unlock. You cannot unlock any of the doors with the remote transmitter if the key is in the ignition switch. TRUNK When you push continuously the TRUNK button during 1s, TRUNK will open. PANIC When you push the PANIC button, horn will alarm. - 2 -
4. Specification 4.1 CPU Type ROM RAM Clock frequency Clock frequency generation Package UPD78F0567(32bit) Manufacturer : Renesas 384KByte 24KByte 4MHz Crystal resonator 144pin QFP 4.2 RF Receive Module Type Local clock frequency Frequency generation Modulation Scheme Bandwidth Carrier Detect Sensitivity G8X-21RX-KO2 Manufacturer: OMRON KOREA 313.85MHz Crystal resonator FM(superheterodyne) ±200 KHz 11dBuVemf 4.3 Others Dimension Weigh Battery Operation Voltage, Current 149mm× 119mm × 35mm 326g CAR Battery(DC 12V) DC12V,50mA (4mA on standby) -40℃ ∼ +80℃ - 4 -
5.Features 5.1 Door lock control The LOCK relay in the receiver drives the door lock actulators to "LOCK"-side when LOCK button of transmitter was pressed. The UNLOCK relay in the receiver drives 5.2 Battery saving To prevent the battery exhaustion , the micro-computer of the transmitter is usually inactive. When the button will be pressed, the micro-computer wakes up immediately and judges which button is pressing. Then the micro-computer constructs the transmission frame and radiates it from the antenna .After transmitting, the micro-computer switches stand-by mode by itself. 6. Derivatives OKA-870R is an integrated controller for a car body control, includes the keyless entry receiver. The integrated. controller consists of the multiple control functions as follows, centralized door lock, turn-signal lamp, room-lamp, intermitted wiper, power window timer, ignition key illumination, warning buzzer and so on. - 5 - Note : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant topart 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference ina residential installation This equipment generates, uses and can radiate radio frequency energy and, if not installedand used in accordance with the instructions, may cause harmful interference to radio communications, However,there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmfulinterference to radio or television reception, which can be determined by turning the equipment off and on, the user isencouraged to try to correct the interference by one or more of the following measures:- Reorient or relocate the receiving antenna.- Increase the separation between the equipment and receiver.- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.- Consult the dealer or an experienced radio/TV technician for help.Modifications not expressly approved by the manufacturer could void the user's authority to operated the equipmentunder FCC rules.

Navigation menu