Omron G8D-444H-A Part 15 Security / Remote Control Transmitter User Manual Manual

Download:
Mirror Download [FCC.gov]
Document ID	125941
Application ID	6CglG2eONsWqexEit/rx2A==
Document Description	Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	9.08kB (113464 bits)
Date Submitted	2000-11-20 00:00:00
Date Available	2000-12-02 00:00:00
Creation Date	2000-11-15 19:10:02
Producing Software	Acrobat 4.0 Scan Plug-in for Windows
Document Lastmod	2000-11-15 19:10:46
Document Title	Manual
Document Creator	Acrobat 4.0 Scan Plug-in for Windows

1. Constitution of the Radio Frequency Keyless Entry
System with Door Lock Controller for vehicle
The radio frequency keyless entry is a system that it controls locking and unlocking the door by
wireless remote controllert This system consists of two components. The TRANSMITTER is a device that
transmits the signal when the button is pressed. The transmission signal consists of several synchronous
frame, data frame, and so on The RECEIVER is fixed inside the vehicle. It works intermittently to prevent
the battery exhaustion. When the receiver detects the synehronous code, It runs continuously to receive the
signals completely. After receiving the signal, the receiver decides which operation will be performed. The
user can select the following operations by pressing the button of the remote transmitter.
OPERATION ACTION
LOCK lock the door
UNLOCK unlock the door (the driver side first, then all doors)
BOOT RELEASE Release the boot
PANIC The horn is heeped, and the headlight and flasher are blinked
Transmitter
f=307.9MHz
2. User’s manual (provisionally)
REMOTE TRANSMITTER
r—
You can lock and unlock your vehicle with the remote transmitter.
LOCK
When you push the LOCK button, all the doors will lock.
You cannot lock any of the doors with the remote transmitter if any door is open or the key is in the
ignition switch.
UNLOCK
When you push the UNLOCK button once, all the door 5 will unlock. If you unlock the doors with the
remote transmitter, but do not open any of the doors within 30 seconds, the doors will automatically relocks.
You cannot unlock any of the doors with the remote transmitter if the key is in the ignition switch.
BOOT RELEASE
To open the boot, push the BOOT RELEASE button for approximately one second.
The boot will not open if the key is in the ignition switch.
PANIC
Panic mode allows you to remotely sound's horn to attention, To activate this mode, press the PANIC
button. Your vehicle's horn will beep for about 30 seconds
To cancel Panic mode before 30 seconds, press any button on the remote transmitter.
! CAUTION
The remote control switch is a precision electronic device. Therefore, pay attention to the following
' Do not impose shock on the remote control switch.
' Keep the remote control switch dry.
- Do not disassemble the remote control switch,
Your keyless entry system operates on a radio frequency subject to Federal Communications Commission
(FCC)rules and Industry Canada rules.
This device complies with Part 15 of the FCC Rules. Operation rs subject to the following two conditions.
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation of the device.
"Complies with RSS-ZIO of Industry Canada."
NOTICE
This equipment has been tested and found to comply with the limits for a Class B devicepursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction, may cause harmful interference to radio oonununioations. However,there is no
guarantee that interference will not occur in a particular installation. If this equipment close cause harmful
interference to radio or television reception, which can be determined by turning the equipment offend on, the
user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or‘ relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC WARNING
Changes or' modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
4. Specification
4.1 CPU ,
Type uPD754244CvS-xxx-BA9 (4bil)
Manufacturer: NEC Corporation
ROM 4K bytes
RAM 128 bytzs
EEPROM 16 bytes
Clock frequency 4.19MHz
Clock frequency generation Ceramic resonator
Package ZOMOP
4.2 RF block
Carrier frequency 307.9MHz
Frequency generation SAW resonator
Modulation FSK
Bit transmission rate 1000bps or SOObpS
Bandwidth 120KHZ
43 Others
Dimension 65.0mmX32r2mmX11‘6mm
Weight 20g
Battery Lithium cell (CRZOZS)
Operation Voltage
Operation temperature
Manufacturer: MATHUSHITA Battery corporation
DC 3v, 20mA
-20"C ~ mot

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.3
Linearized                      : No
Modify Date                     : 2000:11:15 19:10:46+09:00
Create Date                     : 2000:11:15 19:10:02+09:00
Creator                         : Acrobat 4.0 Scan Plug-in for Windows
Producer                        : Acrobat 4.0 Scan Plug-in for Windows
Page Count                      : 4

EXIF Metadata provided by EXIF.tools