Option OGE0301E Multimode GSM/GPRS/EDGE/UMTS/HSDPA PCMCIA Card User Manual 815365

Option NV Multimode GSM/GPRS/EDGE/UMTS/HSDPA PCMCIA Card 815365

Contents

Annex to User Manual

GlobeTrotter Express E
AGENCY REQUIREMENTS
Licensed by QUALCOMM Incorporated under one or more of the following United States Patents and/or their counterparts in
other nations: 4,901,307; 5,490,165; 5,056,109; 5,504,773; 5,101,501; 5,506,865; 5,109,390; 5,511,073; 5,228,054; 5,535,239;
5,267,261; 5,544,196; 5,267,262; 5,568,483; 5,337,338; 5,600,754; 5,414,796; 5,657,420; 5,416,797; 5,659,569; 5,710,784;
5,778,338
Federal communications commission notice
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
> Reorient or relocate the receiving antenna.
> Increase the separation between the equipment and receiver.
> Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
> Consult the dealer or an experienced radio or television technician for help.
Modifications
The FCC requires the user to be notified that any changes or modifications made to this device that are not expressly approved
by Option could void the user's authority to operate the equipment.
Cables
The use of shielded cables for connection of the monitor to the graphics card is required to assure compliance with FCC
regulations.
(Part 15.105 only applies for digital devices in the meaning of the FCC rules)
Declaration of Conformity for products marked with the FCC logo - United States only
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
For questions regarding your product or FCC declaration, contact:
Option | Gaston Geenslaan 14| 3001 Leuven | Belgium
www.option.com
To identify this product, refer to the Part, Series, or Model number found on the product.
This product has successfully completed the PTCRB requirements governing the release of new GSM 850/1900 capable
products into the North American market.
Exposure Information to Radio Frequency Energy
This PCMCIA express card has been tested in different notebooks for compliance with the SAR requirements.
Measured SAR values according to the CE regulations:
The maximum measured body SAR value (averaged over a mass of 10 g and distance between phantom and antenna of 5 mm)
is well below the limit of 2 W/kg.
Measured SAR values according to the FCC regulations:
The maximum measured body SAR value (averaged over a mass of 1 g and distance between phantom and antenna of 5 mm) is
well below the limit of 1.6 W/kg.
This device contains 900/1800 MHz GSM and 2100Mhz WCDMA functions that are not operational in U.S. Territories.
For safe and efficient use the user should keep the antenna of the card at a minimum distance of 1 cm away from his body. All of
the measurements above were performed at a distance of 0.5 cm from the body of the user.
CAUTION: Users concerned with the risk of Radio Frequency exposure may wish to limit the duration of their calls and to position
the antenna as far away from the body as is practical.
European Union declaration of conformity CE 0700
Products bearing the CE marking comply with the R&TTE Directive (99/5/EC), EMC Directive (89/336/EEC) and the Low Voltage
Directive (73/23/EEC) issued by the Commission of the European Community.
Compliance with these directives implies conformity to the following European Norms (in parentheses are the equivalent
international standards and regulations):
Radio Frequency spectrum efficiency:
> EN 301 511, v9.0.2
> EN 301 902-1&2, v2.2.1
> EN 300328:v1.6.1 (2004-11)
Electromagnetic Compatibility
> EN 301 489-1: 2002
Safety and Health
> EN 60950: 2001
> EN 50360 (07/2001)
This product may be used in the following countries:
> All EU Member states
> Iceland
> Switzerland
> Norway
> United States of America
Manufacturer's Disclaimer Statement
The information in this document is subject to change without notice and does not represent a commitment on the part of the
vendor. No warranty or representation, either expressed or implied, is made with respect to the quality, accuracy, or fitness for
any particular purpose of this document. The manufacturer reserves the right to make changes to the content of this document
and/or the products associated with it at any time without obligation to notify any person or organization of such changes. In no
event will the manufacturer be liable for direct, indirect, special, incidental, or consequential damages arising out of the use or
inability to use this product or documentation, even if advised of the possibility of such damages.
For questions regarding your product or declaration, contact:
Option | Gaston Geenslaan 14| 3001 Leuven | Belgium
www.option.com
SYSTEM REQUIREMENTS
> Type II PC-Card slot with cardbus interface
> Must be supplied by a SELV (Safety Extra Low Voltage) circuit with limited power.

Navigation menu