Option OGI0225 GSM/GPRS/EDGE USB Stick User Manual Leaflet GI0225

Option NV GSM/GPRS/EDGE USB Stick Leaflet GI0225

Contents

Leaflet

ICON 225 AGENCY REQUIREMENTS Licensed by QUALCOMM Incorporated under one or more of the following United States Patents and/or their counterparts in other nations: 4,901,307; 5,490,165; 5,056,109; 5,504,773; 5,101,501; 5,506,865; 5,109,390; 5,511,073; 5,228,054; 5,535,239; 5,267,261; 5,544,196; 5,267,262; 5,568,483; 5,337,338; 5,600,754; 5,414,796; 5,657,420; 5,416,797; 5,659,569; 5,710,784; 5,778,338 Federal communications commission notice This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: > Reorient or relocate the receiving antenna. > Increase the separation between the equipment and receiver. > Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. > Consult the dealer or an experienced radio or television technician for help. Modifications The FCC requires the user to be notified that any changes or modifications made to this device that are not expressly approved by Option could void the user's authority to operate the equipment. Cables The use of shielded cables for connection of the monitor to the graphics card is required to assure compliance with FCC regulations. (Part 15.105 only applies for digital devices in the meaning of the FCC rules) Declaration of Conformity for products marked with the FCC logo - United States only This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. For questions regarding your product or FCC declaration, contact: Option | Gaston Geenslaan 14 | 3001 Leuven | Belgium | www.option.com To identify this product we refer to the Part, Series, or Model number found on the product. Exposure Information to Radio Frequency Energy This USB 1.1 device has been tested in different notebooks for compliance with the SAR requirements. Measured SAR values according to the CE regulations: The maximum measured body SAR value (averaged over a mass of 10 g and distance between phantom and antenna of 15 mm) is 0,439 W/kg for GSM900, which is well below the limit of 2 W/kg. The maximum measured body SAR value (averaged over a mass of 10 g and distance between phantom and antenna of 15 mm) is 0,556 W/kg for DCS1800, which is well below the limit of 2 W/kg. The maximum measured body SAR value (averaged over a mass of 10 g and distance between phantom and antenna of 15 mm) is 0,849 W/kg for WCDMA 2100, which is well below the limit of 2 W/kg. Measured SAR values according to the FCC regulations: The maximum measured body SAR value (averaged over a mass of 1 g and bottom of computer in direct contact with phantom) is 0,369 W/kg for GSM850, which is well below the limit of 1.6 W/kg. The maximum measured body SAR value (averaged over a mass of 1 g and bottom of computer in direct contact with phantom) is 0,733 W/kg for PCS1900, which is well below the limit of 1.6 W/kg. CAUTION: • Users concerned with the risk of Radio Frequency exposure may wish to limit the duration of their calls and to position the antenna as far away from the body as is practical. • The USB Stick has been tested with specific integral antenna for SAR compliance with three notebook computers having vertical and horizontal USB slots. The device can be used in notebook computers with substantially similar physical dimensions, construction, and electrical and RF characteristics.
European Union declaration of conformity Products bearing the CE marking comply with the R&TTE Directive (99/5/EC), EMC Directive (89/336/EEC) and the Low Voltage Directive (73/23/EEC) issued by the Commission of the European Community. Compliance with these directives implies conformity to the following European Norms:  Radio Frequency spectrum efficiency: > EN 301 511, v9.0.2 : 2003 > EN 301 908-1, v2.2.1 : 2003 > EN 301 908-2, v2.2.1 : 2003  Electromagnetic Compatibility > EN 301 489-1/-7/-24: 2002  Safety and Health > EN 60950-1/A11:2004 > Vodafone test specification against the European Council Recommendation [1999 519 EC] > The PC card has to be supplied by a limited power source in accordance with clause 2.5 of EN 60950-1/A11:2004 This product may be used in the following countries: > All EU Memberstates > Iceland > Switzerland > Norway > United States of America Manufacturer's Disclaimer Statement The information in this document is subject to change without notice and does not represent a commitment on the part of the vendor. No warranty or representation, either expressed or implied, is made with respect to the quality, accuracy, or fitness for any particular purpose of this document. The manufacturer reserves the right to make changes to the content of this document and/or the products associated with it at any time without obligation to notify any person or organization of such changes. In no event will the manufacturer be liable for direct, indirect, special, incidental, or consequential damages arising out of the use or inability to use this product or documentation, even if advised of the possibility of such damages. For questions regarding your product or declaration, contact: Option | Gaston Geenslaan 14 | 3001 Leuven | Belgium | www.option.com SYSTEM REQUIREMENTS > USB 1.1 slot > Must be supplied by a SELV (Safety Extra Low Voltage) circuit with limited power.

Navigation menu