Option OGLHW-E WLAN/GSM/GPRS/UMTS/HSDPA QUAD BAND PC DATA CARD User Manual

Download:
Mirror Download [FCC.gov]
Document ID	605611
Application ID	53OtkyWc5QejYtiZ+IWQ5w==
Document Description	Users Manual Annex 2
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	4.68kB (58549 bits)
Date Submitted	2005-11-24 00:00:00
Date Available	2005-11-24 00:00:00
Creation Date	2005-11-10 12:29:51
Producing Software	Acrobat Distiller 7.0 (Windows)
Document Lastmod	2005-11-10 12:30:01
Document Title	Ø
Document Creator	Acrobat PDFMaker 7.0 for Word
Document Author:	PetraL

GlobeTrotter Fusion+ EMEA card
AGENCY REQUIREMENTS
Licensed by QUALCOMM Incorporated under one or more of the following United States Patents and/or their counterparts
in other nations: 4,901,307; 5,490,165; 5,056,109; 5,504,773; 5,101,501; 5,506,865; 5,109,390; 5,511,073; 5,228,054;
5,535,239; 5,267,261; 5,544,196; 5,267,262; 5,568,483; 5,337,338; 5,600,754; 5,414,796; 5,657,420; 5,416,797;
5,659,569; 5,710,784; 5,778,338
Federal communications commission notice
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
> Reorient or relocate the receiving antenna.
> Increase the separation between the equipment and receiver.
> Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
> Consult the dealer or an experienced radio or television technician for help.
Modifications
The FCC requires the user to be notified that any changes or modifications made to this device that are not expressly
approved by Option could void the user's authority to operate the equipment.
Cables
The use of shielded cables for connection of the monitor to the graphics card is required to assure compliance with FCC
regulations.
(Part 15.105 only applies for digital devices in the meaning of the FCC rules)
Declaration of Conformity for products marked with the FCC logo - United States only
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
For questions regarding your product or FCC declaration, contact:
Option | Kolonel Begaultlaan 45 | 3012 Leuven | Belgium
www.option.com
To identify this product, refer to the Part, Series, or Model number found on the product.
This product has successfully completed the PTCRB requirements governing the release of new GSM 850/1900 capable
products into the North American market.
Exposure Information to Radio Frequency Energy
This PCMCIA card has been tested in different notebooks for compliance with the SAR requirements.
Measured SAR values according to the CE regulations:
The maximum measured body SAR value (averaged over a mass of 10 g and distance between phantom and antenna of
5 mm) is well below the limit of 2 W/kg.
Measured SAR values according to the FCC regulations:
The maximum measured body SAR value (averaged over a mass of 1 g and distance between phantom and antenna of 5
mm) is well below the limit of 1.6 W/kg.
For safe and efficient use the user should keep the antenna of the card at a minimum distance of 1 cm away from his
body. All of the measurements above were performed at a distance of 0.5 cm from the body of the user.
CAUTION: Users concerned with the risk of Radio Frequency exposure may wish to limit the duration of their calls and to
position the antenna as far away from the body as is practical.
European Union declaration of conformity
CE 0700
Products bearing the CE marking comply with the R&TTE Directive (99/5/EC), EMC Directive (89/336/EEC) and the Low
Voltage Directive (73/23/EEC) issued by the Commission of the European Community.
Compliance with these directives implies conformity to the following European Norms (in parentheses are the equivalent
international standards and regulations):
¾
¾
¾
Radio Frequency spectrum efficiency:
> EN 301 511, v9.0.2
> EN 301 902-1&2, v2.2.1
> EN 300328:v1.6.1(2004-11)
Electromagnetic Compatibility
> EN 301 489-1: 2002
Safety and Health
> EN 60950: 2001
> EN 50360 (07/2001)
This product may be used in the following countries:
> All EU Memberstates
> Iceland
> Switzerland
> Norway
> United States of America
Regarding IEEE 802.11g we currently have the following information about restrictions in the R&TTE countries:
Manufacturer's Disclaimer Statement
The information in this document is subject to change without notice and does not represent a commitment on the part of
the vendor. No warranty or representation, either expressed or implied, is made with respect to the quality, accuracy, or
fitness for any particular purpose of this document. The manufacturer reserves the right to make changes to the content of
this document and/or the products associated with it at any time without obligation to notify any person or organization of
such changes. In no event will the manufacturer be liable for direct, indirect, special, incidental, or consequential damages
arising out of the use or inability to use this product or documentation, even if advised of the possibility of such damages.
For questions regarding your product or declaration, contact:
Option | Kolonel Begaultlaan 45 | 3012 Leuven | Belgium
www.option.com
SYSTEM REQUIREMENTS
> Type II PC-Card slot with cardbus interface
> Must be supplied by a SELV (Safety Extra Low Voltage) circuit with limited power.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : No
Tagged PDF                      : Yes
XMP Toolkit                     : 3.1-701
Producer                        : Acrobat Distiller 7.0 (Windows)
Create Date                     : 2005:11:10 12:29:51+01:00
Creator Tool                    : Acrobat PDFMaker 7.0 for Word
Modify Date                     : 2005:11:10 12:30:01+01:00
Metadata Date                   : 2005:11:10 12:30:01+01:00
Format                          : application/pdf
Title                           : Ø
Creator                         : PetraL
Document ID                     : uuid:72339769-c1a9-4585-ad82-7cc67406220d
Instance ID                     : uuid:b97d14e6-5bf1-4c43-b668-ce2b7fbf0c29
Company                         : Option
Source Modified                 : D:20051110112852
Page Count                      : 2
Page Layout                     : OneColumn
Author                          : PetraL

EXIF Metadata provided by EXIF.tools