Oticon A S FU2MBTE mini BTE Fusion 2 User Manual COMPANY LETTER HEAD
Oticon A/S mini BTE Fusion 2 COMPANY LETTER HEAD
InstallationGuide.pdf
PEOPLE FIRST
Oticon A/S Kongebakken 9 DK-2765 Smørum www.oticon.com
Main +45 39 17 71 00 Fax +45 39 27 79 00 Denmark CVR-no. 42334219 1
Oticon Radio Model - Quick Installation Guide
Radio Model Name: mini BTE Fusion 2
The mini BTE Fusion 2 radio model is a low power,
inductive radio transceiver working at 3.84 MHz consisting
of:
• a Digital-Signal-Processor (DSP)
• a radio Front-End (FE)
• memory (EEPROM)
• antenna coil
• and smaller components
All components are mounted on a flexible Printed-Circuit-
Board (PCB), which is intended to be installed as a module
into Oticon wireless hearing aid devices.
The module also has all voltage regulators included inside
the DSP and FE and buffered data programming inputs
on the board.
The module requires a battery, one or two microphones and
an audio receiver to be attached and must be mounted in an
external plastic shell.
The module is depicted to the right with its main
components and connections:
PEOPLE FIRST
Oticon A/S Kongebakken 9 DK-2765 Smørum www.oticon.com
Main +45 39 17 71 00 Fax +45 39 27 79 00 Denmark CVR-no. 42334219 2
Oticon Radio Model - Regulatory Label Information
Radio Model Name: mini BTE Fusion 2
Contains: FCC ID: U28FU2MBTE
IC: 1350B-FU2MBTE
NOTICE:
This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
Changes or modifications made to this equipment not expressly approved by Oticon A/S may void the FCC authorization to operate this equipment.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.