Overbreak 27200500650 Remote Control Toy Transmitter User Manual

Overbreak, LLC Remote Control Toy Transmitter Users Manual

Users Manual

Download: Overbreak 27200500650 Remote Control Toy Transmitter User Manual
Mirror Download [FCC.gov]Overbreak 27200500650 Remote Control Toy Transmitter User Manual
Document ID518195
Application IDn/Kgs+TKGZNIsTRRH/SpPQ==
Document DescriptionUsers Manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize41.24kB (515526 bits)
Date Submitted2005-02-25 00:00:00
Date Available2005-02-25 00:00:00
Creation Date2005-02-22 16:58:09
Producing SoftwarepdfFactory v1.57 (Windows XP Chinese)
Document Lastmod0000-00-00 00:00:00
Document TitleUsers Manual
Document CreatorpdfFactory http://www.pdffactory.com
Document Author: cee3

Instruction
Manual
Keep this instnxtion manual.
It contains Important lnformatlou
PRODUCT WARNINGS:
l.Caution:The HoverBlimp Is a battery operated product.
2. Recommended for use by children eight years old and older.
3. Keep your face, eyes, fingers. hair. and other body pans away from
the propellers.
4. Only fly the HoverBIimp indoors.
5. Do not expose the HoverBlimp to water, rain, or moisture.
6. Make sure people around you know you are flying the HoverBIimp.
7. Do not fly the HoverBIimp in crowded areas.
8. Do not fly the HoverBlimp in dusty environments.
9. Be sure to turn the HoverBlimp and Controller off when not in use.
10. Do not fly the HoverBlimp near traffic.
11. Do not use the Hoverflllmp If there is any damage to any ofthe
components, including the Blimp, propellers or controller.
12 The toy is not to be connected to more than recommended number of
power supplies
13 The transformer is not a toy.
BATTERY SAFETY:
Insert the batteries correctly as shown to prevent leakage.
Batteries should be inserted and replaced by an adult
Batteries should not be exposed to direct sunlight. high heat. or fire ~
batteries may explode.
Do not mix old batteries with new.
Do not mix alkaline, non-alkaline,or rechargeable batteries.
00 not try to recharge non-rechargeable batteries
ifthe HoverBIimp will not be used for a long period, remove batteries
to prevent leakage and damage. Remove dead batteries from
Controller and Gondola,
Be sure the battery compartments are screwed securely in place.
Do not get the HoverBlimp or any of the components wet. Clean only
with a soft cloth — no fluids.
Do not short circuit the battery terminals.
Dispose of batteries properly. Do not throw them in the household
garbage.
Never dispose of batteries in fire - they may explode.
In case of battery leaks, do not touch the leaking fluid. Place the
leaking battery inside a plastic bag and dispose of properly.
If leaking battery fluid touches your skin or eyes,wash with cool water
for at least 15 minutes.
Rechargeable batteries are to be removed from the toy before charged.
Rechargeable batteries are only to be charged under adult supervision
Only batteriea of the same or equivalent type as recommended are to be used P 2
HOVERBLIMP COMPONENTS
GONDOLA Receiving
antenna
OnIOff
Switch Weights
Storage
Q, BALLAST
WEIGHT
DISKS
Transmitting
antenna
ALIEN
CONTROLLER FIGURES
P,3
BATTERY INSTALLATION
CONTROLLER
2. Insert 2 AA batteries
(not included).
LOpen battery
compartment with
Phillips screwdriver.
BLIMP GONDOLA
2. Insert a 3 volt
1.0pen battery CR! 23A type
compartment with Lithium battery
Phillips screwdriver. (not included).
FLYlNG THE HOVERBLIMP
Preparation
Docking
Tape back. , 719°"
strip 4 '
inflation
Valve
Notch at
hook base
Ora/Off
Switch
1. Using the valve at the
rear of the Hoveralimp.
inflate with helium until
the balloon is firm
Do not over inflate!
WARNING! Hold the blimp
securely after Inflating
because it may fly away
2. After inflating you can
tape the valve to the
balloon by peeling the
backing off the Tape Back
Strip.
3. Add Ballast Weights over
the notch at the base of the
hook until the HoverBIimp
reaches a state of neutral
bouyancy (not rising, not
sinking).
WARNING! Never attempt
to fly your HoverBlimp
outdoors.The wind may
carry it away.
4.Turn the Hoverfilimp ON.
S.Turn the Controller ON.
95
9'd
FLYING THE HOVERBLIMP
Controller functions
POWER INDlCATOR
UP- CENTER MOTOR
Us
To make HoverBlimp rise,
press the UP button.
To make HoverBllmp fly
forward, press buttons L1
and RI.
To make HoverBllmp tum
slowly to the left. press
button R1.
To make HoverBllmp tum
sharp to the Deft, press
buttons L2 and R1,
DOWN- CENTER
moron DOWN
R2- arc-HT moron
BACK
To make HoverBlimp sink.
press the DOWN button.
To make HoverBHmp fly
Backward. press buttons L2
and R2.
To make HoverBIlmp turn
slowiy to the right ,press
button Ll.
To make HoverBlrmp tum
sharp to the right, press
buttons L1 and R2.
P.7
FLYING THE HOVERBLIMP
PLAY AUEN RESCUE!
Test your skillaTry to air-lift
aliens with rescue hook
PLAY IN THE DARK!
Gondola has 3 posltlon
power switch. Set to
ONwlth LED llghts.
“ ON ii; "i ,
y, ON withllghts
When flying in the dark.
allow your eyes time to
adjust m the dark.
Always remember to turn
your HoverBIlmp off.
If left on,the flashing LED
Ilghts may drain the battery.
Controller buttons
glow ln the dark!
Entire ship lights
up from inside!
P.8
FLYING THE HOVERBLIMP
Between flights
turn of!
when not
in use.
I. Always remember to
turn your Controller and
HoverBIimp off. If left on,
the flashing LED lights
may drain the battery.
2.When not using the
HoverBllmp. hook it to lts
base'using the docking
hook and loop at the rear.
3. As time passes, your
HoverBlimp will begin to
lose IiftThis ls due to a
natural seeping of
helium.When this occurs,
adjust the blimp's weight
by removing some of the
Ballast weight disks from
the hook.When the
Hoverfilimp regains a
state of neutral bouyancy
you are ready to fly again
4. Store the Ballast weight
disks that are not being
used by slipping them
we: the notch on the
Base Unit.
P.9
TROUBLE-SHOOTING
Emblem
Propellefs
don't spln
Hoverflllmp
does not
respond to
Controllet
SPECS
Hoverfillmp Gondola battery is low.
The on/ofi switches on the Gondola and
Controllet ate not turned on.
The Contmler‘s battery is low.
The bamety is not lnsemecl conecdy.
Hoverfllimp is too far away.
Recommended age: 8+
Hoverfillmp range: 40 feet
Gondola battery: 3V CHINA type Lithium
Conuollet batteries 2 AA
Controller powet consumption: o.3w (peak)
solution
Check battery 10: conect
hsertlon.
Replace battery.
Tum on Gondola and
Controller.
Check batteries for correct
hsertion as shown on the
bottom of the battefy
compartment
Replace batteries.
Move closer to the
Hoverslimp.
P.10
For a Class B digital device or peripheral, the instructions furnished the user shall include
The following or similar statement, placed in a prominent location in the text of the manual:
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules, These limits are
de5igned to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance With the
instructions, may cause harmful interference to radio communications However,
there is no guarantee that interference will not occur in a particular installation,
If this eqmpment does cause harmful interference to radio or television reception,
which can be determined by tuming the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
-- Reorient or relocate the receiving antenna
v Increase the separation between the equipment and receiver,
-— Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected
-— Consult the dealer or an experienced radio/TV technician for
help
FCC ID:RV827200500650
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference
received, including interference that may cause
undesired operation.
m Product: HoverBIimp
H .. Model : 00650
mhmubflmcon
Actual contams may vary sigmly.
Some assent” rem-red.
Made In China
0 2005 OverbraaKLLC
Hoverfilim is a trademark of Ovetbreak. LLC
Sun Valley, CA 91352
Conforms toASTM F963 P. 1 2

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.2
Linearized                      : No
Title                           : 全頁傳真列印
Author                          : cee3
Creator                         : pdfFactory http://www.pdffactory.com
Producer                        : pdfFactory v1.57 (Windows XP Chinese)
Create Date                     : 2005:02:22 16:58:09
Page Count                      : 12
EXIF Metadata provided by EXIF.tools
FCC ID Filing: RV827200500650

Navigation menu