PANASONIC Telephones Manual L0902580

User Manual: PANASONIC PANASONIC Telephones Manual PANASONIC Telephones Owner's Manual, PANASONIC Telephones installation guides

Open the PDF directly: View PDF PDF.
Page Count: 10

Accessories (included) For extra orders, call 1-800-332-5368.
[] Charger Unit ................................... one [] Battery .............................. one
Charger OrderNo. PQLV30013ZS OrderNo. PQPP511SVC(P-P511)
AC Adaptor OrderNo. KX-TCA1-G(KX-TCA1) [] Belt Clip ............................ one
[] Handset Cover ................................ one Order No. PQKE10340Z1
Order No. PQKK10126Z1
Installation
Connecting the Charger unit . roOu eto
AC Adaptor
•USE ONLY WITH Panasonic AC ADAPTOR KX-TCA1 (Order No. KX-TCA1-G).
•The AC adaptor must remain connected at all times. (It is normal for the adaptor to feel
warm during use.)
Installing the battery
Insert the battery into the handset as shown, matching the correct polarity (_).
Press the battery down until it places into the compartment (@). Close the cover.
- 1 - PQQX13366YA-BM S0402-2062
Charging the battery
Place the handset on the charger and charge for
about 15 hours before initial use.
• The CHARGE indicator lights, a beep sounds and
"Charging" will be displayed.
• Recharge the battery when:
--"Recharge battery" is displayed,
-,,,r--i]" flashes on the display, or
- the handset beeps intermittently while it is in use.
• If the battery has been discharged, the handset will
display"Charge for ZSHRS"and "_---I" when you
place the handset on the charger. The handset will not
work. Keep charging.
Charge Contacts
Handset battery information
After your Panasonic battery is fully charged:
CHARGE
Indicator
While in use (TALK)
While not in use (Standby)
While using the Reception Booster feature
•Clean the charge contacts of the handset and the charger with a soft, dry cloth
once a month. Clean more often if the unit is subject to grease, dust or high
humidity. Otherwise the battery may not charge properly.
time
Up to 4.5 hours
Up to 11 days
Up to 3.5 hours
Wall Mounting
The charger can be wall mounted. Connect the AC adaptor. Install screws using
the wall template below. Mount the charger (O). Slide it down (_) then slide
down to the right (O) until it is secured.
2.45 cm
Screws
To Power
Outlet
Registration
This cordless handset must be registered at the KX-TG2700/KX-TG2720/
KX-TG2730/KX-TG2740 base unit. The handset will be assigned the extension
number at registration. Only one handset can be registered at a time.
Make sure the base unit and the other handsets are not being used.
Registration must be completed within 1 minute.
Button and
Indicator
•The illustration of the base unit is the KX-TG2730.
Soft key (l'_i)
The handset display shows the instructions as shown
on the right.
Base unit: Press ['M-O-f_.
•The MUTE indicator light flashes.
I _i_l [_ ]
Press MUTE on
base unit, then
OK on handset to
register ha_
2Handset:
(_)Press the right soft key (B).
(_)Wait until a long beep sounds and the display
shows the registered number. The registration
will be then complete.
_i_l [_]
Handset
Registering
Ex. Extension number 2
[2]
Handset[2]
Registered
•The registered number" [ 1 ] " to "[ 8 ] " is shown on the top right of the display.
•You can stop registration by pressing _ on the handset and pressing _ on the
base unit.
To cancel the handset registration, please see the KX-TG2700/KX-TG2720/
KX-TG2730/KX-TG2740 Operating Instructions.
Belt Clip
You can hang the handset on your belt or pocket using the belt clip.
To attach the belt clip To remove the belt clip
While pressing the top of the clip (Q),
pull the right edge in the direction of the
arrow (0).
e"
Optional Headset
Plugging an optional headset into the handset allows a hands-free phone
conversation. Please use only the Panasonic KX-TCA88 headset.
To order, call the accessories telephone number on page 1.
Connecting the headset
Open the headset jack cover, and connect the headset to the headset jack as
shown.
Headset Jack
-4-
FCC and Other Information
When programming emergency numbers and/or making test calls to emergency numbers:
1. Remain on the line and briefly explain to the dispatcher the reason for the call before
hanging up.
2. Perform such activities in the off-peak hours, such as early morning hours or late
evenings.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Privacy of communications may not be ensured when using this phone.
CAUTION:
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this device.
Note:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
i Reorient or relocate the receiving antenna.
i Increase the separation between the equipment and receiver.
i Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
i Consult the dealer or an experienced radio/TV technician for help.
Operating near 2.4GHz electrical appliances may cause interference. Move away from
the electrical appliances.
CAUTION:
To comply with FCC RF exposure requirements, the handset should be carried with the
specific belt-clip provided for the handset to ensure compliance. Other non-tested belt-
clips or similar body-worn accessories may not comply, therefore, should be avoided.
This equipment is hearing aid compatible as defined by the FCC in 47 CFR Section
68.316.
When you hold the phone to your ear, noise might be heard in your Hearing Aid. Some
Hearing Aids are not adequately shielded from external RF (radio frequency) energy. If
noise occurs, use an optional headset accessory or the speakerphone option (if
applicable) when using this phone. Consult with your audiologist or Hearing Aid
manufacturer about the availability of Hearing Aids which provide adequate shielding to
RF energy commonly emitted by digital devices.
--5--
CAUTION:
To reduce the risk of fire or injury to persons, read and follow these instructions.
1. Use only the battery(ies) specified.
2. Do not dispose of the battery(ies) in a fire. They may explode. Check with local waste
management codes for special disposal instructions.
3. Do not open or mutilate the battery(ies). Released electrolyte is corrosive and may
cause burns or injury to the eyes or skin. The electrolyte may be toxic if swallowed.
4. Exercise care in handling batteries in order not to short the battery to conductive
materials such as rings, bracelets, and keys. The battery and/or conductor may
overheat and cause burns.
5.Charge the battery(ies) provided with or identified for use with this product only in
accordance with the instructions and limitations specified in this manual.
A nickel cadmium battery that is recyclable powers the
product you have purchased. At the end of its useful life,
under various state and local laws, it is illegal to dispose of
this battery into your municipal waste stream. Please call
1-800-8-BATTERY for information on how to recycle this
battery.
WARNING:
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS PRODUCT
TO RAIN OR ANY TYPE OF MOISTURE.
If you need assistance with the set-up or operation, /
1
please call 1-800-211-PANA(7262) J
Panasonic World Wide Web address: http://www.panasonic.com
for customers in the USA or Puerto Rico
Panasonic's e-mail address for customer inquiries:
consumerproducts @panasonic.com
Panasonic Consumer Electronics Company,
Division of Matsushita Electric Corporation of America
One Panasonic Way, Secaucus, New Jersey 07094
Panasonic Sales Company,
Division of Matsushita Electric of Puerto Rico, Inc.
Ave. 65 de Infanter_a, Km. 9.5, San Gabriel Industrial Park
Carolina, Puerto Rico 00985
-6-
Conexibn de la unidad de carga
r",h Tomacorriente
_,_41,[_ (CA 120 V, 60 Hz)
_ Adaptador de CA
°UTILiCELA SOLAMENTE CON EL ADAPTADOR DE CA KX-TCA1 de Panasonic
(N. ° de pedido KX-TCA1-G).
°El adaptador de CA debera permanecer conectado en todo momento. (Durante la
utilizaci6n es normal que se caliente el adaptador.)
Instalacibn de la bateria
Inserte la bateria en la unidad portatil como se muestra ajustando en la
polaridad correcta ((_)). Presione la bateria hacia abajo hasta encajarla en el
compartimiento ((_)). Cierre la cubierta.
®
-(1)-
Carga de la bateria
Ponga la unidad portatil en el cargador y carguela durante 15 horas
aproximadamente antes de utilizarla por primera vez.
• El indicador CHARGE se encender& sonara un
pitido y se visualizara "Charging".
• Cargue la bateria cuando: Contactos
- se visualice "Recharge battery", de carga
-",r----il" parpadee en la pantalla, o
-la unidad portatil emita pitidos
intermitentemente mientras se utiliza.
• Si la bateria se ha descargado, la unidad portatil visualizara
"Charge for ZSHRS"y ",F"-]" cuando la ponga en el
cargador. La unidad portAtil no funcionar& Deje que se cargue.
Informacibn acerca de la bateria de la unidad portatil
Despues de que su bateria Panasonic este completamente cargada:
Indicador
CHARGE
Mientras se utiliza (HABLAR) Hasta 4.5 horas
Mientras no se utiliza (Espera) Hasta 11 dfas
Mientras se utiliza la funci6n Reception Booster Hasta 3.5 horas
• Limpie los contactosde cargade la unidadport&tily delcargadorcon un pahosuave
y seco unavez al mes.Limpiemas a menudosi la unidadestaexpuestaa lagrasa,
polvoo humedadalta. De Io contrario,la bateria tal vez no se cargue correctamente.
Montaje en pared
El cargador puede montarse en una pared. Conecte el adaptador de CA. Instale
los tornillos utilizando la plantilla para pared de abajo. Monte el cargador (O).
Deslicelo hacia abajo (_) y despues hacia abajo y hacia la derecha (O) hasta
fijarlo en su sitio.
2.45 cm
Tornillos
A la toma
de corriente PLANTILLA
PARA PARED
Registro
Esta unidad porta.til debera ser registrada en la unidad base KX-TG2700/
KX-TG2720/KX-TG2730/KX-TG2740. El nQmero de extensi6n de la unidad
porta.til sera asignado al hacer el registro.
Solamente podra registrarse una unidad porta.til cada vez.
Aseg_rese de que la unidad base y las otras unidades portdtiles no est_n
siendo utilizadas. El registro deberd completarse antes de I minuto.
Tecla blanda (m_',',',',',',',',im)
<
bot6n e indicador
oLailustraci6n de la unidad base es del KX-TG2730.
El visualizador de la unidad portatil muestra las
instrucciones como se muestra a la derecha.
Unidad base: Presione ["M-0-f-_.
oLaluz del indicador MUTE parpadear&
Press MUTE on
base unit, then
OK on handset to
register handset
Unidad portdtil:
(Y)Presione la tecla blanda derecha (Hl_',',',',',',',',iH).
(_)Espere hasta que suene un pitido largo y el
visualizador muestre el nQmero registrado.
Entonces se habra completado el registro.
¢i-i-a[_]
Handset
Registering
Ej., Nt_merode extensi6n2
[2]
Handset[2]
Registered
oEI nt]mero de registro " [ 1 ] " a " [ 8 ] " se mostrara en la parte superior derecha del
visualizador.
oPodra parar el registro presionando _ en la unidad portatil y presionando _ en
la unidad base.
Para cancelar el registro de la unidad porta.til, consulte las instrucciones de
funcionamiento del KX-TG2700/KX-TG2720/KX-TG2730/KX-TG2740.
- (3)-
Utilizaci6n de la presilla para cintur6n
Podra colgar la unidad porta.til en su cintur6n o bolsillo utilizando la presilla para
cintur6n.
Para colocar la presilla para cintur6n Para quitar la presilla para cintur6n
Mientras presiona la parte superior de
la presilla (Q), tire del borde derecho
en el sentido de la flecha (O).
Auricular opcional
Enchufando un auricular opcional a la unidad portatil le podra conversar por
telefono con las manos libres. Utilice solamente el auricular Panasonic KX-TCA88.
Para hacer el pedido, Ilame al nOmero de telefono para accesorios de la pagina 1.
Conexi6n del auricular
Abra la tapa de la toma para auricular y conecte el auricular a la toma para
auricular como se muestra.
Toma para auricular
- (4) -

Navigation menu