PAX Technology P90 Mobile Payment Terminal User Manual

User Manual

We declare that:

※ The product is installed with battery separately in the box. The FCC ID

label is placed on the mobile phone clearly visible to all persons at the time

of purchase.

※ The user is cautioned that changes or modifications not expressly

approved by the manufacturer could void the user’s authority to operate

the equipment.

※ This device complies with part 15 of the FCC Rules. Operation is

subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including

interference that may cause undesired operation.

※ Do not attempt to disassemble the mobile phone and battery by yourself.

Non-expert handling of the devices may damage them.

※ Your wireless phone is a radio transmitter and receiver. It is designed

and manufactured not to exceed limits for exposure to radio frequency (RF)

energy set by the Federal Communications

※ Commission (FCC) of the U.S. Government. These limits are part of

comprehensive guidelines and establish permitted levels of RF energy for

the general population. The guidelines are based on standards that were

developed by independent scientific organizations through periodic and

thorough evaluation of scientific studies. The standards include a

substantial safety margin designed to assure the safety of all persons,

regardless of age or health. The exposure standard for wireless fixed

phoned employs a unit of measurement known as the Specific Absorption

Rate, or SAR. The SAR limits set by the FCC are 1.6W/kg. Tests for SAR

are conducted using standard operating positions accepted by the FCC

with the phone transmitting as its highest certified power level in all tested

frequency bands. Although the SAR is determined at the highest certified

power level, the actual SAR level of the phone while operating can be well

below the maximum value. This is because the phone is designed to

operate at multiple power levels so as to use only the power required to

reach the network. In general, the closer you are to a wireless base station,

the lower the output power.