PEAG JLab Audio EPICBT Bluetooth Earbunds User Manual Epic Bluetooth Quickstart

user manual

This device complies with Industry Canada licence-exempt RSS

standard(s). Operation is subject to the following two conditions:

(1)this device may not cause interference, and(2) this device must

accept any interference, includinginterference that may cause

undesired operation of the device.

Le présent appareil est conforme aux CNR d'Industrie Canada

applicables auxappareils radio exempts de licence. L'exploitation

est autorisée aux deux conditions suivantes :(1) l'appareil ne doit

pas produire de brouillage, et(2) l'utilisateur de l'appareil doit

accepter tout brouillage radioélectrique subi, même si le brouillage

est susceptible d'en compromettre lefonctionnement.

NOTE: This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates uses and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception, which

can be determined by turning the equipment off and on, the user is encouraged to

try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help

Changes or modifications not expressly approved by the party responsible for compliance

could void the user's authority to operate the equipment. This device complies with Part

15 of the FCC Rules. Operation is subject to the following two conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may

cause undesired operation.

RF Exposure Information:

This product is compliance to FCC RF Exposure requirements and

refers to FCC website https://apps.fcc.gov/oetcf/eas/reports/GenericSearch.cfm

search for FCC ID: 2AHYVEPICBT.