PEGATRON 10242HD Set Top Box User Manual

PEGATRON CORPORATION Set Top Box

User Manual.pdf

DRAFTIMPORTANT SAFETY INSTRUCTIONS 1) Read these instructions. 2) Keep these instructions. 3) Heed all warnings. 4) Follow all instructions. 5) Do not use this apparatus near water. 6) Clean only with dry cloth. 7) Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. 8) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 9) Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding-type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.10) Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.11) Only use attachments/accessories specified by the manufacturer.12) Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.13) Unplug this apparatus during lightning storms or when unused for long periods of time.14) Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as a power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.Power Source WarningA label on this product indicates the correct power source for this product. Operate this product only from an electrical outlet with the voltage and frequency indicated on the product label. If you are uncertain of the type of power supply to your home or business, consult your service provider or your local power company.The AC inlet on the unit must remain accessible and operable at all times.Ground the ProductWARNING: Avoid electric shock and re hazard! If this product connects to coaxial cable wiring, be sure the cable system is grounded (earthed). Grounding provides some protection against voltage surges and built-up static charges.WARNING: Avoid electric shock and re hazard! Do not locate an outside antenna system in the vicinity of overhead power lines or power circuits. Touching power lines or circuits might be fatal. This product may contain a tuner capable of receiving o-the-air broadcasts.Protect the Product from LightningIn addition to disconnecting the AC power from the wall outlet, disconnect the signal inputs.Verify the Power Source from the On/O Power LightWhen the on/o power light is not illuminated, the apparatus may still be connected to the power source. The light may go out when the apparatus is turned o, regardless of whether it is still plugged into an AC power source. Eliminate AC Power/Mains OverloadsWARNING: Avoid electric shock and fire hazard! Do not overload AC power/mains, outlets, extension cords, or integral convenience receptacles. For products that require battery power or other power sources to operate them, refer to the operating instructions for those products.Provide Ventilation and Select a Location• Remove all packaging material before applying power to the product. • Do not place this apparatus on a bed, sofa, rug, or similar surface.• Do not place this apparatus on an unstable surface.• Do not install this apparatus in an enclosure, such as a bookcase or rack, unless the installation provides proper ventilation.• Do not place entertainment devices (such as VCRs or DVDs), lamps, books, vases with liquids, or other objects on top of this product.• Do not block ventilation openings.Notice to InstallersThe servicing instructions in this notice are for use by qualied service personnel only. To reduce the risk of electric shock, do not perform any servicing other than that contained in the operating instructions, unless you are qualied to do so.Note to System InstallerWARNINGTO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE.For this apparatus, the coaxial cable shield/screen shall be grounded as close as practical to the point of entry of the cable into the building.For products sold in the US and Canada, this reminder is provided to call the system installer's attention to Article 820-93 and Article 820-100 of the NEC (or Canadian Electrical Code Part 1), which provides guidelines for proper grounding of the coaxial cable shield.This symbol is intended to alert you that uninsulated voltage within this product may have sufficient magnitude to cause electric shock.Therefore, it is dangerous to make any kind of contact with any inside part of this product.Ce symbole a pour but d’alerter toute personne qu’un contact avec une pièce interne de ce produit, sous tension et non isolée, pourrait être suffisant pour provoquer un choc électrique. Il est donc dangereux d’être en contact avec toute pièce interne de ce produit.This symbol is intended to alert you of the presence of important operating and maintenance (servicing) instructions in the literature accompanying this product. Ce symbole a pour but de vous avertir qu’une documentation importante sur le fonctionnement et l’entretien accompagne ce produit.CAUTION: To reduce the risk of electric shock, do not remove cover (or back). No user-serviceable parts inside. Refer servicing to qualified service personnel.Operating EnvironmentThis product is designed for operation indoors with a temperature range from 32° to 104° F (0° to 40°C). Each product should have adequate spacing on all sides so that the cooling air vents on the chassis are not blocked.Protect from Exposure to Moisture and Foreign ObjectsWARNING: Avoid electric shock and re hazard! Do not expose this product to dripping or splashing liquids, rain, or moisture. Objects lled with liquids, such as vases, should not be placed on this apparatus.WARNING: Avoid electric shock and re hazard! Unplug this product before cleaning. Do not use a liquid cleaner or an aerosol cleaner. Do not use a magnetic/static cleaning device (dust remover) to clean this product.WARNING: Avoid electric shock and re hazard! Never push objects through the openings in this product. Foreign objects can cause electrical shorts that can result in electric shock or re. Service WarningsWARNING: Avoid electric shock! Do not open the cover of this product. Opening or removing the cover may expose you to dangerous voltages. If you open the cover, your warranty will be void. This product contains no user-serviceable parts.Check Product SafetyUpon completion of any service or repairs to this product, the service technician must perform safety checks to determine that this product is in proper operating condition.Protect the Product When Moving ItAlways disconnect the power source when moving the apparatus or connecting or disconnecting cables. Compliance InformationUnited States FCC ComplianceFederal Communications Commission Interference StatementThis device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.This device has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against such interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy. If not installed and used in accordance with the instructions, it may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment OFF and ON, the user is encouraged to try to correct the interference by one or more of the following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.• Consult the service provider or an experienced radio/television technician for help.Any changes or modications not expressly approved by Cisco Systems, Inc., could void the user’s authority to operate the equipment.IMPORTANT NOTE: FCC RF Exposure Statement:This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body.This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.Cisco Explorer G10 Multi-Screen Gateway SeriesModels: 10455HD, 10455HDC, 10242HDManufactured by: Cisco Systems, Inc. 170 West Tasman Drive San Jose, CA 95134 USA www.cisco.com/go/contactsFCC Caution:• Any changes or modications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.• This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.Canada EMI RegulationThis Class B digital apparatus complies with Canadian ICES-003.Cet appareil numérique de la class B est conforme à la norme NMB-003 du Canada.IMPORTANT NOTE: Canada RF Exposure Statement:This system has been evaluated for radio frequency exposure for humans in reference to Canada Health Code 6 (2009) limits. The evaluation was based on evaluation per RSS-102 Rev 4. The minimum separation distance from the antenna to the general bystander is 7.9 inches (20 cm) to maintain compliance.Cisco and the Cisco logo are trademarks or registered trademarks of Cisco and/or its aliates in the U.S. and other countries. To view a list of Cisco’s trademarks, go to this URL: www.cisco.com/go/trademarks.Third-party trademarks mentioned are the property of their respective owners. The use of the word partner does not imply a partnership relationship between Cisco and any other company. (1110R)Manufactured under license from Dolby Laboratories. Dolby and the double-D symbol are trademarks of Dolby Laboratories. The terms HDMI and HDMI High-Denition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks of HDMI Licensing LLC in the United States and other countries. Rovi is a trademark of Rovi Corporation. © 2015 Cisco and/or its aliates. All rights reserved. Last Updated: September 2015 Part Number 78-100795-01A0L’exposition humaine aux radiofréquences émises par ce système a été évaluée conformément aux limites spéciées dans le Code de sécurité6 de Santé Canada (2009). Cette évaluation était basée sur l’évaluation décrite dans le document RSS-102 Rev 4. Cette norme dénit à 20cm (7,9po) la distance minimale devant séparer l’antenne de toute personne. IC Statement:This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: • this device may not cause interference, and • this device must accept any interference, including interference that may cause undesired operation of the device.• Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes: 1. l’appareil ne doit pas produire de brouillage, et 2. l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.• This Class B digital apparatus complies with Canadian ICES-003.• Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.• This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter, except tested built-in radios. • Cet appareil et son antenne ne doivent pas être situés ou fonctionner en conjonction avec une autre antenne ou un autre émetteur, exception faites des radios intégrées qui ont été testées. AVC VIDEO LICENSEWith respect to each AVC/H.264 product, we are obligated to provide the following notice:THIS PRODUCT IS LICENSED UNDER THE AVC PATENT PORTFOLIO LICENSE FOR THE PERSONAL USE OF A CONSUMER OR OTHER USES IN WHICH IT DOES NOT RECEIVE REMUNERATION TO (i) ENCODE VIDEO IN COMPLIANCE WITH THE AVC STANDARD (“AVC VIDEO”) AND/OR (ii) DECODE AVC VIDEO THAT WAS ENCODED BY A CONSUMER ENGAGED IN A PERSONAL ACTIVITY AND/OR WAS OBTAINED FROM A VIDEO PROVIDER LICENSED TO PROVIDE AVC VIDEO. NO LICENSE IS GRANTED OR SHALL BE IMPLIED FOR ANY OTHER USE. ADDITIONAL INFORMATION MAY BE OBTAINED FROM MPEG LA, L.L.C. SEE HTTP://WWW.MPEGLA.COM.Accordingly, please be advised that service providers, content providers, and broadcasters may be required to obtain a separate use license from MPEG LA prior to any use of AVC/H.264 encoders and/or decoders.ROVI CORPORATION COPYRIGHT NOTICEThis product incorporates copyright protection technology that is protected by U.S. patents and other intellectual property rights of Rovi Corporation. Use of this copyright protection technology must be authorized by Rovi Corporation, and is intended for home and other limited viewing uses only unless otherwise authorized by Rovi Corporation. Reverse engineering and disassembly are prohibited.DisclaimersCisco Systems, Inc. assumes no responsibility for errors or omissions that may appear in this manual. We reserve the right to change this manual at any time without notice.Cisco will not be responsible for any licensing fees payable to Rovi Corporation, and Cisco will not have any indemnication obligations relating to any claims asserted by Rovi Corporation, or by any entity controlled by, controlling, or under common control with Rovi Corporation (“Rovi Entities”), or any entity used to license intellectual property of the Rovi Entities, and the successors and assigns of the foregoing entities, including any claim related to electronic programming guides alone or in combination with any equipment provided by Cisco.Open Source License StatementCisco Explorer G10 Multi-Screen Gateway Series contain, in part, certain free and/or open source software (“Open Source”) under separate license terms. Examples of such licenses may include all versions of the GNU General Public License (GPL), GNU Lesser General Public License (LGPL), BSD license, MIT license, Mozilla Public License, Eclipse Public License, Apache license, and others. To nd specic information regarding the Open Source in your product, including copies of the applicable license documentation and related information, go to: (i) for North America http://www.cisco.com/web/consumer/support/open_source.html, or (ii) for outside North America http://www.cisco.com/web/consumer/support/open_source.html#international. Once at the site, search for the product listing and click the related items identied. If you have any questions or problems accessing any of the links, contact: spvtg-external-opensource-requests@cisco.com.

Navigation menu