Packard Bell Grafite And Carbon Cs036A00 Users Manual &
CS036A00 to the manual 94440f73-4fb6-47f8-8ecb-9bca49566965
2015-02-03
: Packard-Bell Packard-Bell-Grafite-And-Carbon-Cs036A00-Users-Manual-466894 packard-bell-grafite-and-carbon-cs036a00-users-manual-466894 packard-bell pdf
Open the PDF directly: View PDF
Page Count: 7
- Packard Bell
- Grafite & Carbon
- Disassembly Manual
- Table of Contents
- About this Guide
- For More Information
- Technician Notes
- Disassembly
- Turn OFF the power using the power button and disconnect the AC adapter.
- Do not disassemble the device into parts that are smaller than those specified here.
- Label all removed connectors; note where the connector goes and in what position.
- Use something to hold the small screws (trays, jars, or cups). Label each cup with the disassembly step number. This can reduce questions about where each screw came from during re-assembly.
- Reassembly
- The LED cable goes on the outside of the hard disk drive casing, not underneath the drive!
- Required Tools
- Front Cover
- Note: Use an anti-static mat or something soft like a piece of cloth underneath the device to prevent damage to the exterior of the casing.
- Fig. 1 Removing the front cover.
- Top Cover
- Fig. 2 Removing the top cover.
- Hard Disk Drive
- Note: One of the screws on each side of the hard disk drive holds a spacer clip.
- Fig. 3 Removing the hard disk drive screws.
- Note: In Fig. 3 only 2 screws are visible; the other 2 screws are located on the other side of the hard disk drive.
- Fig. 4 Removing the hard disk drive.
- I/O Board
- Fig. 5 Removing the I/O board.
- Notice