Pantech GA-400B DUAL-BAND HANDHELD User Manual Revised

Download:
Mirror Download [FCC.gov]
Document ID	444408
Application ID	C1gSlBbwxPR6Y7YDlW8UHw==
Document Description	USERS MANUAL
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	0.9kB (11238 bits)
Date Submitted	2004-06-28 00:00:00
Date Available	2004-06-28 00:00:00
Creation Date	2004-06-25 16:20:15
Producing Software	Acrobat Distiller 6.0 (Windows)
Document Lastmod	2004-06-25 16:20:15
Document Title	Microsoft Word - Revised USER MANUAL.doc
Document Creator	PScript5.dll Version 5.2
Document Author:	rita

USER MANUAL
_ Find the file named “GA-400B User's Manual.pdf”
* __ ___ ____ ___ ___ ___ ___.
FCC & Industry Canada Regulatory Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Your mobile device is a low power radio transmitter and receiver. When it is ON, it
receives and also sends out radio frequency (RF) signals. In August 1996, the Federal
Communications Commission (FCC) adopted RF exposure guidelines with safety levels
for mobile device. Those guidelines are consistent with safety standards previously set
by both U.S. and international standards bodies: American National Standard Institute
(ANSI), National Council of Radiation Protection and Measurements (NCRP), and
International Commission on Non-Ionizing Radiation Protection (ICNRP). Those
standards were based on comprehensive and periodic evaluations of the relevant
scientific literature. The design of your Module complies with the FCC guidelines and
applicable Statement according to FCC part 15.105
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
. Reorient or relocate the receiving antenna.
. Increase the separation between the equipment and receiver.
. Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
. Consult the dealer or an experienced radio/TV technician for help.
Statement according to FCC part 15.21
Modifications not expressly approved by this company could void the user's authority to
operate the equipment.
RF exposure FCC
For body worn operation, to maintain compliance with FCC RF exposure guidelines, use
only accessories that contain no metallic components and provide a separation distance
of 25mm (0.6 inches) to the body. Use of other accessories may violate FCC RF
exposure guidelines and should be avoided.
This device and its antenna must not be co-located or operating in conjunction with any
other antenna or transmitter.
Health and Safety Information FCC
This EUT has been shown to be capable of compliance for localized specific absorption
rate (SAR) for uncontrolled environment/general population exposure limits specified in
ANSI/IEEE Std. C95.1-1992 and had been tested in accordance with the measurement
procedures specified in FCC/OET Bulletin 65 Supplement C (2001) and IEEE Std. 1528200X (Draft 6.5, January 2002).
Ministry of Health (Canada), Safety Code 6. The standards include a substantial safety
margin designed to assure the safety of all persons, regardless of age and health. The
exposure standard for wireless mobile phones employs a unit of measurement known as
the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6W/kg *.
* In the U.S. and Canada, the SAR limit for mobile phones used by the public is 1.6
watts/kg (W/kg) averaged over one gram of tissue. The standard incorporates a
substantial margin of safety to give additional protection for the public and to account for
any variations in.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : No
Page Count                      : 2
XMP Toolkit                     : XMP toolkit 2.9.1-13, framework 1.6
About                           : uuid:8e803b29-fabd-4099-9411-e9320db630f3
Producer                        : Acrobat Distiller 6.0 (Windows)
Create Date                     : 2004:06:25 16:20:15-04:00
Creator Tool                    : PScript5.dll Version 5.2
Modify Date                     : 2004:06:25 16:20:15-04:00
Document ID                     : uuid:d4ce8a2d-db3f-4701-b7c8-9d8dd0d0486d
Format                          : application/pdf
Title                           : Microsoft Word - Revised USER MANUAL.doc
Creator                         : rita
Author                          : rita

EXIF Metadata provided by EXIF.tools