Paradox Security Systems NVR35M Wireless PIR detector User Manual NVR35M EI01

Paradox Security Systems Wireless PIR detector NVR35M EI01

Users Manual

PARADOX.COMWireless Outdoor/IndoorWindow and Sliding DoorDual Detector withAnti-Masking andPet ImmunityNVR35M-EI01General DescriptionThe NVR35M module provides a superior wireless outdoor and indoor solution for window and sliding door protection, with two operation modes: Pet Immune Mode 7.5 x 2m (25 x 7 ft) and Sharp Mode (indoor use) 10 x 2m (33 x 7 ft) with dual verification detection. Installing the NVR35M1. Remove the front cover - open the Captive screw.2. Remove the Main Unit: open the two snap-lock mechanisms on each side of the back cover attaching the Main Unit to the back cover as displayed below. Then remove the Main Unit.3. Pull the wires from the control panel through the knockout holes and mount the back cover onto the window frame or wall using screws..4. Attach the Main Unit to the back cover - ensure the locks snap closed.. 5. Insert two AA butteries.6. Set DIP switch settings (see Table 1 below) according to requirements. Figure 6 – Adjusting the settingsTable 1: DIP Switch Func tionality* For USA and Canada: 433MHz frequency is set by the manufacturer and cannot be modified.7. Set Range/PIR Sensitivity level: Turn the Sensitivity Trimmer (see Figure 6 above) to select the required level as displayed below.. Figure 7 – Sensitivity Trimmer8. Replace the front cover and close the Captive screw.Warning: Do not obscure the detector's field of view.Testing the NV35MXPerform a Walk-Test to test successful installation: Walk slowly across the far end of the detection range. Ensure detection.Walk test mode lasts 5 minutes after the tamper screw is closed. Figure 1 – Removing the Front Cover Figure 2 – Main Unit Figure 3 – Removing the Main Unit Figure 4 – Mounting the Back Cover Front coverCaptive screwMountingscrew 1MountingTamper screw 2Tamper knockout hole Knockout holes Figure 5 – Attaching the Main UnitDip Switch Number Function Mode Description1LEDON: DefaultOFF: 2PET Immunity/SHARP ModeON: PET Immunity modeOFF: SHARP mode*3 RFON: 433MHz * (default)OFF: 868MHz- applicable for EU versions only123DIP switchesSensitivitytrimmerDefault PIR Sensitivity level: 2Note: After selecting the required level, the LED flashes the number of times equal to the level selected. EXAMPLE: If level 2 is selected, the LED flashes twice.NVR35MInstallation Manual V1.0
PARADOX.COMBeam PatternPET ModeSHARP ModeTop ViewLED DisplayTechnical SpecificationsNotificationChanges or modifications to this equipment not expressly approved by the party responsible for compliance (Paradox Security Systems Ltd.) could void the user’s authority to operate the equipment.WarrantyThe Limited Warranty Statement found on the website www.paradox.com/terms.Your use of the Paradox product signifies your acceptance of these terms and conditions. The following US patents may apply 5,886,632 and 6,215,399, Other Canadian and international patents may apply.Printed in Canada 04/2015.Feature LED Status IndicatorFeature LED Status IndicatorTamper open Green: ON for 0.3 seconds every 30 seconds PIR sensitivity level setting Green: Flashes 1-3 times according to the selected levelAlarm detection Red: ON for 2 secondsBooting Green/Red alternating flashes for 30 seconds Model Number NVR35MInfrared sensor type 2 dual elementsDetection range PET ON: up to 7.5mSharp ON: up to 10mDetection range • PET Immunity mode: up to 7.5m 7.5 x 2m (25 x 7 ft)• Sharp mode: 10 x 2m (33 x 7 ft)Anti- mask Active IR detection for blocking 30cm and sprayed liquidInput voltage 3VDC=2x1.5VDC AA Alkaline batteriesCurrent consumption 40μA in Standby 30mA in Alarm/RF TransmittingBattery life 3 years of typical useLow battery voltage Signal2.5VCompatibility RTX3 and Magellan systemsOutdoor protection IP54Operation temperature -35°c / +50°cRelative humidity 95% non-condensingRF Frequency 433.92 MHZ/868MHzIMPORTANT: For US and Canada, only 433.92 MHz is usedDimensions 12.3 x 6.1 x 4.3 cm (4.8 x 2.4 x 1.7 in.) Certifications EN50131-2-2 Grade 2, Class IVCertification Body: Applica Test & CertificationWeight 100g / 0.2 lb

Navigation menu