Pass and Seymour d b a Legrand CM7000 Outdoor IR HD Bullet IP Camera User Manual LNA full page 2 surface fold marks

Pass & Seymour, Inc. d/b/a Legrand Outdoor IR HD Bullet IP Camera LNA full page 2 surface fold marks

Users Manual

Installation Instructions • Notice ďInstallation Instrucciones de Instalación
Catalog Number(s) • Numéro(s) de Catalogue • Les Numéros de Catalogue:
Country of Origin: Made in China • Pays ďorigine: Fabriqué en Chine • Pais de origen: Hecho en China
Outdoor IR IP Camera
Caméra extérieure IP IR
Cámara IP IR al aire libre
Doc. #1507215 03/14 Rev A
CM7000
INSTALLATION INSTRUCTIONS
Please read these instructions completely before you begin.
NOTICE D’INSTALLATION
Veuillez lire toutes ces instructions avant de commencer.
1
INSTALLATION
INSTALLATION
INSTALACIÓN
Wallplate
Plaque murale
Placa de montaje
Run Cat 5 cable from enclosure mounted device supplying power over Ethernet (PoE) to single gang box at intended camera location
Feed Camera cables through hole in supplied Wallplate, and attach Cat 5 cable with Ethernet PoE to Camera cable RJ45 jack, and mount Wallplate
to single gang box using supplied rubber gasket
Attach Camera to Wallplate using provided screws
Plug in Cat 5 cable with POE and Camera is ready for use (see online User Guide at legrand.us/ipcameras for additional info)
Exécutez câble Cat 5 de dispositif monté enceinte alimentation par Ethernet (PoE) pour boîtier encastré à l'emplacement de la caméra prévue
Nourrir les câbles de la caméra par trou dans la plaque murale fournie et attacher câble Cat 5 avec Ethernet PoE à caméra câble RJ45 jack et Mont
plaque murale pour boîte de jonction simple utilisant le joint en caoutchouc
Joindre photo pour plaque murale à l'aide de vis fournies
Câble Cat 5 de brancher avec POE et la caméra est prête à l'emploi (voir le Guide de l'utilisateur en ligne legrand.us/ipcameras pour plus d'infos)
Cable Cat 5 funcionamiento del recinto montado dispositivo de alimentación sobre Ethernet (PoE) a la caja única banda en ubicación de la cámara
prevista
Los cables de la cámara de alimentación a través del agujero en la placa de montaje suministrado y conecte cable Cat 5 con Ethernet PoE conector
RJ45 del cable de cámara, y placa de montaje a la caja simple con junta de goma suministrados
Conectar la cámara a la placa de montaje mediante tornillos provistos
Enchufe el cable Cat 5 con POE y cámara está listo para usar (consulte la guía del usuario en línea para legrand.us/ipcameras obtener información
adicional)
IR Array
Et tableau
Y arreglos de
discos
Camera Lens
Objectif de la
caméra
Lente de la cámara
Cat 5 cable
connection
Plaque murale
Placa de montaje
860.233.6251
1.877.BY.LEGRAND
www.legrand.us
www.legrand.ca
© Copyright 2014 Legrand All Rights Reserved.
© Copyright 201
4 Tous droits réservés Legrand.
© Copyright 201
4 Legrand Todos los derechos reservados.
Doc. #1507215 03/14 Rev A
2
CM7000 SPECIFICATIONS
CM7000 SPÉCIFICATIONS
CM7000 ESPECIFICACIONES
ComplianceConformité Conformidad
FCC Notice - FCC ID: YV8-CM7000
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
Ce dispositif est conforme à la partie 15 des directives FCC. L'utilisation du dispositif doit répondre aux deux conditions suivantes : (1) Ce dispositif ne doit pas générer d'interférences
dangereuses et (2) ce dispositif doit supporter toutes les interférences reçues, y compris les interférences susceptibles de provoquer des dysfonctionnements.
Este dispositivo cumple con el apartado 15 de las reglas de la FCC. El funcionamiento queda sujeto a las siguientes dos condiciones: (1) Este dispositivo no puede causar interferencias
perjudiciales y (2) este dispositivo debe admitir cualquier interferencia que reciba, incluidas aquellas que pudieran causar un funcionamiento no deseado.
Caution: Any changes or modifications to this device not explicitly approved by Legrand could void your authority to operate this equipment.
Mise en garde : Toute altération ou modification de ce dispositif non approuvée de manière explicite par Legrand peut invalider votre droit à utiliser cet appareil.
Precaución: Cualquier cambio o modificación que se realice en este dispositivo y que no esté aprobado/a explícitamente por Legrand podría anular su autoridad para operar este
equipo.
Video Compression
H.264, MJPEG
Image Sensor Resolution
1/3”, 1.2 Megapixel Progressive Scan CMOS, 1280H x 960V
Image Sensor Sensitivity
Day/Night Mode (exceptional low noise level, low light sensitivity)
Shutter: 1/10000 – 1/30 second
Focal Length
3.6mm
Aperture
F1.8
Field Angle (FOV)
100.2°(D) x 77°(H) x 54°(V)
IR Cut Filter
Yes, Mechanical
Day & Night Mode
IR LED covering up to 10 meter
Minimum Illumination
0.05 Lux; 0 Lux with IR LED On
Responsivity
5.48V/Lux-sec (550nm)
Supported Maximum Video
Resolution and Frame Rate
1280x960 (25fps)
1280x720 (30fps)
Video Bit Rate
32 Kbps ~ 8 Mbps, Multi-rate for Preview & Recording
Embedded Analytics
Motion Detection (up to 16 target areas)
Pre-/post-alarm Buffer
8MB
Snapshots
Triggered upon events, Send via email/FTP
Network Protocol
TCP/UDP/IP, RTP/RTCP, RTSP, DHCP, DDNS, HTTP, HTTPS, SMTP,
FTP, NTP and Wi-Fi (802.11b/g/n)
SIP/VoIP Support
Yes
Power over Ethernet (PoE)
IEEE 802.3af, Class 0
External Cable Connection
Network: RJ45, 10M/100M Auto-Sensing
Audio In from external mic - 3.5mm
Audio Out to external amplified speaker 3.5mm
Power Input
Dimensions (D x L)
94mm (D) x 230mm (L)
Weight
0.52kg
Temperature / Humidity
Operating: -20°C ~ 4C (-4°F ~ 113°F)
10 ~ 90%, RH(non-condensing)
Storage: -30°C ~ 60°C (-22°F ~ 140°F)
Non-PoE Power Requirement
12VDC/1A; Input: 100240VAC, 5060Hz
Casing
IP66 Compliant Weather-Proof Metal Case
Compliance
FCC Part 15,Subpart B Class B; EN 55022 Class B, EN 61000-3-2, EN
61000-3-3, EN 55024, EN 60950-1; C-tick AS/NZS CISPR 22
CISPR 24; IP66
Legrand PoE Devices
IEEE 802.3af (15.4W)
DA2400 PoE Injector
DA1458 Gig Switch w/PoE
Legrand Power Supply
PW7760 12VDC 1.5A

Navigation menu