Pass and Seymour d b a Legrand SA7522 2.4 GHz Band RF Lighting Controller User Manual revised

Download:
Mirror Download [FCC.gov]
Document ID	3916455
Application ID	dDAuColYMwgosrZC9JJWlQ==
Document Description	Users Manual revised
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	7.57kB (94630 bits)
Date Submitted	2018-07-09 00:00:00
Date Available	2018-07-18 00:00:00
Creation Date	2018-06-07 10:18:38
Producing Software	Foxit PhantomPDF Printer Version 9.1.0.531
Document Lastmod	2018-06-07 10:18:38
Document Title	Users Manual revised

Legrand Home Systems
SA7522 Modular Radio – Instruction Manual
The SA7522 modular radio is an embedded modular radio designed to be used only with our proprietary host devices.
The SA7522 cannot be used as a standalone device and is not intended to be sold to any parties.
The SA7522 modular radio is installed inside host devices by mating it’s connectors to connectors on the board of host
devices.
The SA7522 modular radio should not be installed within a system operating simultaneously with other transmitters.
The host system shall have a label showing: Contains FCC ID: YV8-SA7522, IC: 9922A-SA7522
Federal Communication Commission Declaration of Conformity Statement
This device complies with Part 15 Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.”
Warning: Changes or modifications to this device not expressly approved by Legrand Home Systems could void the
user’s authority to operate the equipment.
Legrand Home Systems
Canadian Compliance Statement
This Class B digital apparatus meets all requirements of the Canadian Interference Causing Equipment Regulations.
Operation is subject to the following two conditions:
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
RF Exposure Safety Information
In accordance with FCC requirements of human exposure to radio frequency fields, the radiating element shall be
installed such that a minimum separation distance of 20cm is maintained between it and the user or general population.
Proper use of this radio in accordance to the following guidelines will result in RF exposure that is below the FCC
recommended limits.
1. The host devices are typically wall mounted devices and are not hand held. Most parts of the body, especially the
face or eyes typically will be further than the minimum distance while operating.
2. When using any component containing the modular radio, maintain a minimum distance of 7.9 inches or 20 cm or
more from the body of all persons.
3. Only operate the modular radio in the following Legrand host devices: RF Switches, and RF Switch Slave
devices.
Legrand Home Systems
301 Fulling Mill Road / Suite G
Middletown PA 17057
877.295.3472
Fax: 717.702.2546
www.legrand.us

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.7
Linearized                      : No
Page Count                      : 2
Modify Date                     : 2018:06:07 10:18:38-04:00
Producer                        : Foxit PhantomPDF Printer Version 9.1.0.531
Title                           : 
Author                          : 
Subject                         : 
Creator                         : 
Create Date                     : 2018:06:07 10:18:38-04:00

EXIF Metadata provided by EXIF.tools