Paxton Access 6903M2 Net2 Hands Free Keycard - mk2 User Manual

Paxton Access Ltd Net2 Hands Free Keycard - mk2 INSTRUCTION Hands free Keycard for Net2

a href="https://usermanual.wiki/Paxton-Access" itemprop="url"> Paxton Access >

User Manual

Ins-30106-US Hands free Keycard for Net2 24/04/2009Technical SupportTechnical help is available: Monday - Friday from 12:00 AM - 5:00 PM (PST) Saturday from 1:00 AM - 5:00 AM (PST)1.800.672.PAXT support@paxton.co.ukThe keycard has been designed with features to extend battery life, these include a two second timeout once access has been granted and a capability to prevent repeated access to the same door whilst the keyfob remains in the eld of the reader. Leaving the keycard in the eld of a reader will reduce battery life.The hands free interface has a pair of switches labelled SW2. Select either switch 1 or 2 to set which button the interface will respond to and then power cycle the interface to store this setting.Interface Settings To enable the buttons, the keycard must rst be presented to the P series reader and then used in hands free mode. The keycard stores the details of this interface and can then activate the door using a button.It can still be used in normal hands free mode and also in local passive mode with other standard readers.The keycard can store up to 14 doors, seven for each button. Data Reset To clear the stored gate information from the keycard hold down both buttons until the beep sounds continually.The system comprises of a Hands Free Interface, a compatible reader (see specication table) and hands free keycards or keyfobs. The system operates by using the eld being transmitted by the P series reader to wake up the token. This then communicates with the interface which contains a long range receiver.The keycard increases this effective read range to typically 5 yds (maximum 50 yds). This is achieved by activating the system manually instead of using the reader eld (maximum 8 feet)Keycards also include a standard EM4100 proximity ID chip and can therefore be presented to any compatible proximity reader whether they are using the Hands Free interface or not.What is Hands Free?Documentation on all Paxton Access products can be found on our web site - http://www.paxton-access.com/The card will beep as conrmation when it has communictated with the hands free interface.This does NOT mean that access has been granted as that is determined by the access permissions assigned to the user.SW2Hands free interface Switch settings
3 3/8 in2 1/8 in 3/8 inEM4100 - 125 kHz 2.4 GHz0 °C (32 °F) 50 °C (122 °F)1 x CR2430P38 3 ftP50 4 ftP75 5 ftP200 8 ft6 ft16 ftSpecicationsCarrier frequencyOperating temperatureElectricalEnvironment DimensionsMin MaxWidthHeightDepthP200E metal mount Read range with Hands Free tokenSystem SpecicationTypical Battery LifeBattery TypeWith button - all readers > 5 yds5 yearsSAFETY WARNINGRISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONSBattery replacementThe battery is retained by a spring clip cover. Locate the small slot aperture below its bottom edge. Restrain the cover with gentle pressure while lifting the lower edge with a small screwdriver. The spring clips on the cover will release to reveal the battery.Once the battery has been replaced, place the cover directly above the opening and push down to latch it home.Long range readerFCC ComplianceThis device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Token typeWe hereby declare that the Net2 Hands Free Keycard mk2 FCC ID: USE6903M2 is a portable device which has a maximum transmit power of 0.24 mW and is not subject to the routine RF exposure evaluation as per Section 2.1093 of the FCC rules.
Download:
Mirror Download [FCC.gov]
Document ID1102544
Application IDo8xjgcbO2YPaGjUzBXqd9Q==
Document DescriptionUser Manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize27.35kB (341905 bits)
Date Submitted2009-04-28 00:00:00
Date Available2009-04-28 00:00:00
Creation Date2009-04-28 08:42:40
Producing SoftwareAdobe PDF Library 7.0
Document Lastmod2009-04-28 08:45:38
Document TitleINSTRUCTION - Hands free Keycard for Net2
Document CreatorAdobe InDesign CS2 (4.0.5)
FCC ID Filing: USE6903M2

Navigation menu