Installation Directions

: Pdf 1000427779-Installationsheet 1000427779-InstallationSheet B5 unilog

Open the PDF directly: View PDF .
Page Count: 3

INS #

Installation Instructions

Model# GMT-G

Model# GMTL-N

Model# GMT-V

Model# GM-V

Low Voltage / Dry Contact Switches

General Information

The GM series of low voltage dry contact switches are

available in a three wire momentary (SPDT), three wire

momentary locking (SPDT), and a two wire maintained

style (SPST). These switches can be used with any

Greengate lighting controller.

Getting Started

1. Do not discard these installation instructions. Please

keep for future reference and operation information.

2. It is recommended that all low voltage wiring be

done with power removed to the logic board to

protect components from potential shorts during the

wiring process.

3. Use only as intended and at the listed voltage.

4. All installation and service must be performed by

qualified personnel or service technicians.

5. Install in accordance with the National Electrical Code

and any other codes which may apply.

6. Installation and wiring information contained in this

document is based on industry-accepted standards

and practices. If conflicts exist between these

instructions and any applicable codes or ordinances,

please contact Greengate before proceeding with the

installation.

7. High voltage is present inside the lighting enclosure.

Use extreme caution when performing maintenance

on this equipment.

8. Document all wiring and device terminations and

locations so that devices can be properly configured

and programmed for operation.

Mounting Detail

1. Rough-in the appropriate size wall box for the switch

plate ordered.

2. Once wiring is complete, install the switch into the

wall box with the provided screws.

3. Mount the switch face plate to the wall switch with

the provided screws.

Wiring Detail

All low voltage wiring is Class 2 wiring and must enter

the lighting controller enclosure through the low voltage

section of the enclosure. All low voltage wiring must be

run in separate conduit from line voltage wiring. Failure to

separate high voltage from low voltage wiring may cause

interference with logic board function.

For all momentary SPDT switches, cabling should be 18

AWG twisted, three-conductor, unshielded cable. For all

maintained SPST switches, cabling should be 18 AWG

twisted, two-conductor unshielded cable. Maximum

length for dry contact closure device wiring is 1000 feet.

2

Key Switch Model Operation

Connections are made to terminal screws on the wall

switch. The ground screw of the wall switch will not be

used in this low voltage installation.

Momentary style switches may be wired in parallel to

the same switch channel if they control the same lighting

loads (3-way application). Maintained style switches are

not recommended for 3 way applications. If used in this

application, each maintained style switch will need to be

homerun to the lighting controller and wired to a separate

low voltage switch channel.

Key Switch Model Operation

To operate key switch models, keys are taped to back of switch

upon receipt. Insert the single tab end of the key into the slot

near the top or bottom of the switch and press up or down to

actuate the switch.

Eaton

1000 Eaton Boulevard

Cleveland, OH 44122

United States

Eaton.com

Eaton’s Cooper Controls Business

203 Cooper Circle

Peachtree City, GA 30269

CooperControl.com

© 2014 Eaton

All Rights Reserved

Printed in USA

P/N: 9850-000471-00

Eaton is a registered trademark.

All trademarks are property

of their respective owners.

Eaton est une marque de commerce

déposée. Toutes les autres marques

de commerce sont la propriété de leur

propriétaire respectif.

Eaton es una marca comercial

registrada. Todas las marcas

comerciales son propiedad de sus

respectivos propietarios.

WARRANTIES AND LIMITATION OF LIABILITY

Please refer to www.coopercontrol.com under the Legal section for our terms and conditions.