1.1.3.5 Packet Tracer Configuring IPv4 And IPv6 Interfaces Instructions

1.1.3.5%20Packet%20Tracer%20-%20Configuring%20IPv4%20and%20IPv6%20Interfaces%20Instructions

1.1.3.5%20Packet%20Tracer%20-%20Configuring%20IPv4%20and%20IPv6%20Interfaces%20Instructions

User Manual: Pdf

Open the PDF directly: View PDF PDF.
Page Count: 2

© 2013 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public. Page 1 of 2
Packet Tracer - Configuring IPv4 and IPv6 Interfaces
Topology
Addressing Table
Device
Interface
IPv4 Address
Subnet Mask
Default Gateway
IPv6 Address/Prefix
R1
G0/0
172.16.20.1
255.255.255.128
N/A
G0/1
172.16.20.129
255.255.255.128
N/A
S0/0/0
209.165.200.225
255.255.255.252
N/A
PC1
NIC
172.16.20.10
255.255.255.128
172.16.20.1
PC2
NIC
172.16.20.138
255.255.255.128
172.16.20.129
R2
G0/0
2001:DB8:C0DE:12::1/64
N/A
G0/1
2001:DB8:C0DE:13::1/64
N/A
S0/0/1
2001:DB8:C0DE:11::1/64
N/A
Link-local
FE80::2
N/A
PC3
NIC
2001:DB8:C0DE:12::A/64
FE80::2
PC4
NIC
2001:DB8:C0DE:13::A/64
FE80::2
Objectives
Part 1: Configure IPv4 Addressing and Verify Connectivity
Part 2: Configure IPv6 Addressing and Verify Connectivity
Packet Tracer - Configure IPv4 and IPv6 Interfaces
© 2013 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public. Page 2 of 2
Background
Routers R1 and R2 each have two LANs. Your task is to configure the appropriate addressing on each device
and verify connectivity between the LANs.
Note: The user EXEC password is cisco. The privileged EXEC password is class.
Part 1: Configure IPv4 Addressing and Verify Connectivity
Step 1: Assign IPv4 addresses to R1 and LAN devices.
Referring to the Addressing Table, configure IP addressing for R1 LAN interfaces, PC1 and PC2. The serial
interface has already configured.
Step 2: Verify connectivity.
PC1 and PC2 should be able to ping each other and the Dual Stack Server.
Part 2: Configure IPv6 Addressing and Verify Connectivity
Step 1: Assign IPv6 addresses to R2 and LAN devices.
Referring to the Addressing Table, configure IP addressing for R2 LAN interfaces, PC3 and PC4. The serial
interface is already configured.
Step 2: Verify connectivity.
PC3 and PC4 should be able to ping each other and the Dual Stack Server.

Navigation menu