6.3.3.8 Packet Tracer Inter VLAN Routing Challenge Instructions

6.3.3.8%20Packet%20Tracer%20-%20Inter-VLAN%20Routing%20Challenge%20Instructions

6.3.3.8%20Packet%20Tracer%20-%20Inter-VLAN%20Routing%20Challenge%20Instructions

User Manual: Pdf

Open the PDF directly: View PDF PDF.
Page Count: 2

© 2013 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public. Page 1 of 2
Packet Tracer – Inter-VLAN Routing Challenge
Topology
Addressing Table
Device Interface IP Address Subnet Mask Default Gateway
R1
G0/0 172.17.25.2 255.255.255.252 N/A
G0/1.10 172.17.10.1 255.255.255.0 N/A
G0/1.20 172.17.20.1 255.255.255.0 N/A
G0/1.30 172.17.30.1 255.255.255.0 N/A
G0/1.88 172.17.88.1 255.255.255.0 N/A
G0/1.99 172.17.99.1 255.255.255.0 N/A
S1 VLAN 99 172.17.99.10 255.255.255.0 172.17.99.1
PC1 NIC 172.17.10.21 255.255.255.0 172.17.10.1
PC2 NIC 172.17.20.22 255.255.255.0 172.17.20.1
PC3 NIC 172.17.30.23 255.255.255.0 172.17.30.1
Packet Tracer – Skills Integration Challenge
© 2013 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public. Page 2 of 2
VLAN and Port Assignments Table
VLAN Name Interface
10 Faculty/Staff Fa0/11-17
20 Students Fa0/18-24
30 Guest(Default) Fa0/6-10
88 Native G0/1
99 Management VLAN 99
Scenario
In this activity, you will demonstrate and reinforce your ability to implement inter-VLAN routing, including
configuring IP addresses, VLANs, trunking and subinterfaces.
Requirements
• Assign IP addressing to R1 and S1 based on the Addressing Table.
• Create, name and assign VLANs on S1 based on the VLAN and Port Assignments Table. Ports should
be in access mode.
• Configure S1 to trunk, allow only the VLANs in the VLAN and Port Assignments Table.
• Configure the default gateway on S1.
• All ports not assigned to a VLAN should be disabled.
• Configure inter-VLAN routing on R1 based on the Addressing Table.
• Verify connectivity. R1, S1, and all PCs should be able to ping each other and the cisco.pka server.

Navigation menu