6.4.1.2 Packet Tracer Skills Integration Challenge Instructions

6.4.1.2%20Packet%20Tracer%20-%20Skills%20Integration%20Challenge%20Instructions

User Manual: Pdf

Open the PDF directly: View PDF PDF.
Page Count: 2

© 2013 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public. Page 1 of 2
Packet Tracer – Skills Integration Challenge
Topology
Packet Tracer – Skills Integration Challenge
© 2013 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public. Page 2 of 2
Addressing Table
Device
Interface
IP Address
Subnet Mask
Default Gateway
VLAN
R1
S0/0/0
172.31.1.2
255.255.255.0
N/A
N/A
G0/0.10
172.31.10.1
255.255.255.0
N/A
10
G0/0.20
172.31.20.1
255.255.255.0
N/A
20
G0/0.30
172.31.30.1
255.255.255.0
N/A
30
G0/0.88
172.31.88.1
255.255.255.0
N/A
88
G0/0.99
172.31.99.1
255.255.255.0
N/A
99
S1
VLAN 88
172.31.88.33
255.255.255.0
172.31.88.1
88
PC-A
NIC
172.31.10.21
255.255.255.0
172.31.10.1
10
PC-B
NIC
172.31.20.22
255.255.255.0
172.31.20.1
20
PC-C
NIC
172.31.30.23
255.255.255.0
172.31.30.1
30
PC-D
NIC
172.31.88.24
255.255.255.0
172.31.88.1
88
VLAN Table
VLAN
Interfaces
10
F0/11-15
20
F0/16-20
30
F0/5-10
88
F0/21-24
99
G0/1
Scenario
In this activity, you will demonstrate and reinforce your ability to configure routers for inter-VLAN
communication and configure static routes to reach destinations outside of your network. Among the skills you
will demonstrate are configuring inter-VLAN routing, static and default routes.
Requirements
Configure inter-VLAN routing on R1 based on the Addressing Table.
Configure trunking on S1.
Configure four directly attached static route on HQ to each VLANs 10, 20, 30 and 88.
Configure directly attached static routes on HQ to reach Outside Host.
- Configure the primary path through the Serial 0/1/0 interface.
- Configure the backup route through the Serial 0/1/1 interface with a 10 AD.
Configure a directly attached default route on R1.
Verify connectivity by making sure all the PCs can ping Outside Host.

Navigation menu