7.4.1.2 Packet Tracer Skills Integration Challenge Instructions

7.4.1.2%20Packet%20Tracer%20-%20Skills%20Integration%20Challenge%20Instructions

7.4.1.2%20Packet%20Tracer%20-%20Skills%20Integration%20Challenge%20Instructions

User Manual: Pdf

Open the PDF directly: View PDF PDF.
Page Count: 2

© 2013 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public. Page 1 of 2
Packet Tracer - Skills Integration Challenge
Topology
Addressing Table
Device Interface IP Address Subnet Mask Default Gateway
HQ
G0/0 172.16.127.254 255.255.192.0 N/A
G0/1 172.16.63.254 255.255.192.0 N/A
S0/0/0 192.168.0.1 255.255.255.252 N/A
S0/0/1 64.104.34.2 255.255.255.252 64.104.34.1
Branch
G0/0 N/A
G0/1 N/A
S0/0/0 192.168.0.2 255.255.255.252 N/A
HQ1 NIC 172.16.64.1 255.255.192.0 172.16.127.254
HQ2 NIC 172.16.0.2 255.255.192.0 172.16.63.254
HQServer.pka NIC 172.16.0.1 255.255.192.0 172.16.63.254
B1 NIC
B2 NIC 172.16.128.2 255.255.240.0 172.16.143.254
BranchServer.pka NIC 172.16.128.1 255.255.240.0 172.16.143.254
Scenario
In this challenge activity, you will finish the addressing scheme, configure routing, and implement named access
control lists.
Packet Tracer - Skills Integration Challenge
© 2013 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public. Page 2 of 2
Requirements
a. Divide 172.16.128.0/19 into two equal subnets for use on Branch.
1) Assign the last usable address of the second subnet to the Gigabit Ethernet 0/0 interface.
2) Assign the last usable address of the first subnet to the Gigabit Ethernet 0/1 interface.
3) Document the addressing in the Addressing Table.
4) Configure Branch with appropriate addressing
b. Configure B1 with appropriate addressing using the first available address of the network to which it is
attached. Document the addressing in the Addressing Table.
c. Configure HQ and Branch with RIPv2 routing according to the following criteria:
• Advertise all three attached networks. Do not advertise the link to the Internet.
• Configure appropriate interfaces as passive.
d. Set a default route on HQ which directs traffic to S0/0/1 interface. Redistribute the route to Branch.
e. Design a named access list HQServer to prevent any computers attached to the Gigabit Ethernet 0/0
interface of the Branch router from accessing HQServer.pka. All other traffic is permitted. Configure the
access list on the appropriate router, apply it to the appropriate interface and in the appropriate direction.
f. Design a named access list BranchServer to prevent any computers attached to the Gigabit Ethernet 0/0
interface of the HQ router from accessing the Branch server. All other traffic is permitted. Configure the
access list on the appropriate router, apply it to the appropriate interface and in the appropriate direction.

Navigation menu