MFJ 906_v1a 906 6 Meter Antenna Tuner

User Manual: Pdf MFJ--906-6-Meter-Antenna-Tuner

Open the PDF directly: View PDF PDF.
Page Count: 6

DownloadMFJ-906_v1a MFJ--906-6-Meter-Antenna-Tuner
Open PDF In BrowserView PDF
MFJ-906 Instruction Manual

6-Meter Antenna Tuner

General Information
MFJ's 6 Meter antenna tuner for the Magic Band gives you low SWR with
practically any coax-fed antenna: mobile whips, dipoles, verticals, vees,
random wires, beams.
With low SWR, your rig will be more efficient; you'll get more power out of
your 6 meter transceiver and into your antenna for more DX, it will run cooler
and last longer, and your expensive transceiver will be protected from
overheating due to high SWR.
A lighted Cross-Needle SWR/Wattmeter shows SWR, forward and reflected
power simultaneously in 300/60 forward and 30/6 reflected Watt ranges and has
an ON/OFF lamp switch. With a built-in bypass switch, you can bypass your
tuner and connect your transceiver directly to your antenna.
The MFJ-906 handles 100 Watts FM and 200 Watts SSB PEP. It works with all
solid state and tube rigs and is perfect for home and mobile use. The MFJ-906
measures 8" x 2 1/2" x 3". The meter lamp uses 12 Vdc.

Installation
The MFJ-906 installs between your 6 meter transceiver and your antenna.
Connect the MFJ-906's TRANSMITTER SO-239 to your 6 meter transceiver,
and the ANTENNA SO-239 to your antenna. The meter lamp is powered by
12Vdc, through the POWER jack on the rear panel. Use an optional MFJ1312B or another power transformer that provides 12V, 300 mA.

Operation
1.

Ensure that the TUNER switch on the front panel is depressed in to the
TUNE position.

2.

For high power transmitters (30 Watts and up), depress the METER switch
in to the HI position. For less than 30 Watts, this switch should be out, in
the LO position.

3.

Set TRANSMITTER and ANTENNA controls to 5 (capacitors half
opened).

4.

Apply enough transmitter power to give an adequate indication on your
SWR meter. Do not apply full power while tuning for minimum SWR!

5.

Referring to the cross-needle meter on the front panel, adjust the
TRANSMITTER control for a drop in SWR.

6.

Adjust the ANTENNA control until minimum SWR is achieved.

Note: Ignore the bottom scale
1

MFJ-856 Instruction Manual

Directional AC Line Noise Meter

Note: Since the TRANSMITTER and ANTENNA controls interact, they must
be adjusted alternately until minimum SWR is obtained.
7.

To bypass the MFJ-906, place the TUNER switch on the front panel out to
the BYPASS position.

MFJ-906 Front Panel

MFJ-906 Rear Panel

TECHNICAL ASSISTANCE
If you have any problem with this unit first check the appropriate section of this
manual. If the manual does not reference your problem or your problem is not
solved by reading the manual you may call MFJ Technical Service at 662-3230549 or the MFJ Factory at 662-323-5869. You will be best helped if you have
your unit, manual and all information on your station handy so you can answer
any questions the technicians may ask.
You can also send questions by mail to MFJ Enterprises, Inc., 300 Industrial
Park Road, Starkville, MS 39759; by Facsimile to 662-323-6551; or by email to
techinfo@mfjenterprises.com. Send a complete description of your problem, an
explanation of exactly how you are using your unit, and a complete description
of your station.

2

MFJ-906 Instruction Manual

SCHEMATIC

3

6-Meter Antenna Tuner

MFJ-856 Instruction Manual

Directional AC Line Noise Meter

DISCLAIMER

Information in this manual is designed for user purposes only and is not
intended to supersede information contained in customer regulations, technical
manuals/documents, positional handbooks, or other official publications. The
copy of this manual provided to the customer will not be updated to reflect
current data.

Customers using this manual should report errors or omissions,
recommendations for improvements, or other comments to MFJ Enterprises,
300 Industrial Park Road, Starkville, MS 39759. Phone: (662) 323-5869; FAX:
(662) 323-6551. Business hours: M-F 8-4:30 CST.

4

MFJ-906 Instruction Manual

6-Meter Antenna Tuner

LIMITED 12 MONTH WARRANTY
MFJ Enterprises, Inc. warrants to the original owner of this product, if manufactured by MFJ
Enterprises, Inc. and purchased from an authorized dealer or directly from MFJ Enterprises, Inc. to
be free from defects in material and workmanship for a period of 12 months from date of purchase
provided the following terms of this warranty are satisfied:
1. The purchaser must retain the dated proof-of-purchase (bill of sale, canceled check, credit
card or money order receipt, etc.) describing the product to establish the validity of the
warranty claim and submit the original or machine reproduction of such proof of purchase to
MFJ Enterprises, Inc. at the time of warranty service. MFJ Enterprises, Inc. shall have the
discretion to deny warranty without dated proof-of-purchase. Any evidence of alteration,
erasure, or forgery shall be cause to void any and all warranty terms immediately.
2. MFJ Enterprises, Inc. agrees to repair or replace at MFJ's option without charge to the
original owner any defective product under warranty provided the product is returned postage
prepaid to MFJ Enterprises, Inc. with a personal check, cashiers check, or money order for
$10.00 covering postage and handling.
3. This warranty is NOT void for owners who attempt to repair defective units. Technical
consultation is available by calling the Service Department at 662-323-0549 or the MFJ
Factory at 662-323-5869.
4. This warranty does not apply to kits sold by or manufactured by MFJ Enterprises, Inc.
5. Wired and tested PC board products are covered by this warranty provided only the wired and
tested PC board product is returned. Wired and tested PC boards installed in the owner's
cabinet or connected to switches, jacks, or cables, etc. sent to MFJ Enterprises, Inc. will be
returned at the owner's expense unrepaired.
6. Under no circumstances is MFJ Enterprises, Inc. liable for consequential damages to person
or property by the use of any MFJ products.
7. Out-of-Warranty Service: MFJ Enterprises, Inc. will repair any out-of-warranty product
provided the unit is shipped prepaid. All repaired units will be shipped COD to the owner.
Repair charges will be added to the COD fee unless other arrangements are made.
8. This warranty is given in lieu of any other warranty expressed or implied.
9. MFJ Enterprises, Inc. reserves the right to make changes or improvements in design or
manufacture without incurring any obligation to install such changes upon any of the products
previously manufactured.
10. All MFJ products to be serviced in-warranty or out-of-warranty should be addressed to:
MFJ Enterprises, Inc.
300 Industrial Park Road
Starkville, Mississippi 39759 USA
and must be accompanied by a letter describing the problem in detail along with a copy of
your dated proof-of-purchase and a daytime telephone number.
11. This warranty gives you specific rights, and you may also have other rights which vary from
state to state.

5

MFJ-856 Instruction Manual

Directional AC Line Noise Meter

6



Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : Yes
XMP Toolkit                     : 3.1-701
Producer                        : Acrobat Distiller 7.0 (Windows)
Creator Tool                    : PScript5.dll Version 5.2
Modify Date                     : 2006:02:15 15:01:14-06:00
Create Date                     : 2006:02:15 15:01:14-06:00
Format                          : application/pdf
Title                           : Microsoft Word - MFJ-906_v1a.DOC
Creator                         : Nicholas Bass
Document ID                     : uuid:19012e82-b808-4368-b1df-7c776f0e3a65
Instance ID                     : uuid:59f31dd6-7d78-4a61-b0a5-7dc308483ce2
Page Count                      : 6
Author                          : Nicholas Bass
EXIF Metadata provided by EXIF.tools

Navigation menu