Perfect Tech Co 807 BT807 User Manual
Perfect Tech Co ., Ltd BT807
user manual
BT-807
BT-807
BT-807
BT-807
BT-807
BT-807
BT-Headset
BT-807
4-6
Battery dead. When the BT-807
battery has almost run down,the light
will flash red and a beep will be heard
in the earpiece. Please change battery.
Multifunction
buttom
Volume +
Volume -
BT-807
BT-807
BT-807
Mute Function During a conversation,
press the "volume -"for 2 seconds to
activate "Mute" mode. To deactivate it,
briefly press the "volume +" for 2
seconds.
BT-807
BT-807
BT-807
BT-807
BT-807
BT-807
Multifunction
Multifunction
BT-807
The fully charged has power for up
to 5-15 hours of talktime, up to hours
of 50-150 standby time depends on
the battery.
However, the times may vary when
used with different mobile phones or
other compatible Bluetooth devices,
usage settings, usage styles, and
environments.
BT-807
The fully charged has power for up
to 5-15 hours of talktime, up to hours
of 50-150 standby time depends on
the battery.
However, the times may vary when
used with different mobile phones or
other compatible Bluetooth devices,
usage settings, usage styles, and
environments.
Do not use the device during charging.
Federal Communications Commission (FCC) Statement
15.21
You are cautioned that changes or modifications not expressly approved
by the part responsible for compliance could void the user’s authority to
operate the equipment.
15.105(b)
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Operation is subject to the following two conditions:
1) this device may not cause interference and
2) this device must accept any interference, including interference that
may cause undesired operation of the device.
FCC RF Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for
an uncontrolled environment. End users must follow the specific operating
instructions for satisfying RF exposure compliance. This transmitter must
not be co-located or operating in conjunction with any other antenna or
transmitter.