Performance Designed PL9929R Afterglow Universal/ XBOX360/ PS3 Wireless Headset User Manual VIII

Performance Designed Products, LLC Afterglow Universal/ XBOX360/ PS3 Wireless Headset VIII

User manual VIII

Download: Performance Designed PL9929R Afterglow Universal/ XBOX360/ PS3 Wireless Headset User Manual VIII
Mirror Download [FCC.gov]Performance Designed PL9929R Afterglow Universal/ XBOX360/ PS3 Wireless Headset User Manual VIII
Document ID1768772
Application IDgYtllKwCRd8fv1dRfG3WYg==
Document DescriptionUser manual VIII
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize323.89kB (4048583 bits)
Date Submitted2012-08-17 00:00:00
Date Available2012-08-20 00:00:00
Creation Date2012-08-13 17:20:01
Producing SoftwareiText 2.1.7 by 1T3XT
Document Lastmod2012-08-13 17:20:01
Document TitleUser manual VIII
Document Creatorpdfsam-console (Ver. 2.4.0e)

13
AFFEIQGLOW®
WIRELESS HEADSET
POWER each/meme:
The wireless Afterglowm headset has a buillrin,
rechargeable Lithium battery that will last 10 lo 12
hours. depending on use and lighting mode.
- The headset comes partially charged, but it's
recommended that you lully charge the headset
using the provided ‘lO' Play 81 Charge
cable prior to use.
- it will take approximately 3 hours to fully charge a
completely drained hattery.
- When charging, the Aiterglow lights will pulsate
indicating positive charge.
- When fully charged, the Aflerglow lights Wlll go back
to the last active lighting mode and stop pulsating.
Low Battery:
~ The Aiterglow headset Wlll play a tone to warn the
user that it's running low on battery.
- This low battery tone will play once every minute
until the battery is completely out of power.
- Playtime is estimated to be ‘lO minutes once the
headset goes into low battery state.
- Plug the provided 10‘ use Play at Charge cable into
the headset and the other end into the
console/computer to charge while headset is active.
- The headset can also be charged while it‘s OFF.
Note: Some gaming consoles and computers Do
NOT provide power to their use oorts when they are
OFF. The headset needs a powered USB port in
orderto complete charging.
- Closed back dynamic headphones.
~ 50mm drivers with Neodymium rarerearth magnets.
- 20 degree angled acoustic baffle tor accurate,
linear sound reproduction.
- Audio frequency response: onz e ZOKhz at 115dB.
- Digital signal processor with
customized audio algorithms.
- 2.4gl-iz wireless communication
via Avnera technology
~ 900mAh rechargeable Lithium Polymer
battery ~10 hours oi battery life.
AFFEQGLOW® WIRELESS HEADSET
TROUBLE OOTING
NO SOUND:
- Make sure the headset is powered ON; you can tell the headset is ON when the
microphone tip LED is a solid solor , if it is flashing or alternating between colors,
the headset has not found the transmitter.
' Check that the headphone volume is turned up.
- Check that the game/chat balance is in the middle or towards "game".
- Make sure the USB transmitter is plugged in to a powered USB port and the LED on it is solid.
' Check that the cable attached to the USB transmitter is
plugged into an audio source with live audio.
- Make sure the headset is charged or is charging while it's ON.
OTHER PLAYERS CAN NOT HEAR ME:
. Check that the microphone is not muted. The microphone tip LED will blink once every
minute when the microphone is muted.
' On Xbox”: Make sure you're connected to Xbox LIVE” and the chat cable (green) is
plugged into both the controller and the headset.
- On PS3®: In the Audio device settings menu, select "Afterglowm Headset” as the
incoming and outgoing chat source.
MY XBOX 360” IS CONNECTED TO TV WITH HDMI AND I CAN'T GET GAME SOUND
FROM MV CONSOLE:
Leave your Xbox 360“ HDMI connection to TV intact.
Try this alternative (direct to TV) connection method; (note the set up may vary
depending on your TV audio out capabilities).
1. Plug the Afterglow” USB transmitter into the front USB port of the Xbox 360“ console.
2. Plug the RCA (Red/White) ends of the transmitter's audio cable into the TV's "Audio Out."
3. If your TV does not have an RCA audio out: disconnect the RCA cable of the USB
transmitter at its breakaway and expose the headphone jack.
4. Plug the headphone jack of the USB transmitter into TV's headphone input.
5. Turn the TV, console, and headset power ON.
If your TV does not have RCA or Headphone inputs then you will need an Xbox 3600 HDMI
adapter. This adapter is NOT included in the box. You can obtain this adapter free of charge
by contacting PDP support.
If you have followed all of these instructions and still have issues please contact PDP
customer service at 17800733173844 (USA and Canada Only)
or visit www.pdp.com/support for more information.
14

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.5
Linearized                      : No
Page Count                      : 2
Creator Version                 : 15
Container Version               : 9
Creator                         : Adobe Illustrator(R) 15.0
For                             : matthew morin,
Title                           : Afterglow Wireless Headset Manual - pages.pdf
Create Date                     : 7/24/12 10:22 PM
Bounding Box                    : -621 -7123 602 9
Producer                        : iText 2.1.7 by 1T3XT
Modify Date                     : 2012:08:13 17:20:01+08:00
EXIF Metadata provided by EXIF.tools
FCC ID Filing: X5B-PL9929R

Navigation menu