Philips AJ3232B/79 User Manual Quick Start Guide Aj3232b 79 Qsg Aen

AJ3232B/79 Quick start guide aj3232b_79_qsg_eng Clock Radio AJ3232B/79 | PhilipsAJ3232B/79

User Manual: Philips AJ3232B/79 Quick start guide Clock Radio AJ3232B/79 | PhilipsAJ3232B/79

Open the PDF directly: View PDF PDF.
Page Count: 2

DownloadPhilips AJ3232B/79 User Manual Quick Start Guide Aj3232b 79 Qsg Aen
Open PDF In BrowserView PDF
1	 Important

Always there to help you

Register your product and get support at

www.philips.com/support

AJ3232

Question?
Contact
Philips

•	
•	
•	

Safety

The product shall not be exposed to dripping or splashing.
Do not place any sources of danger on the product (e.g.
liquid filled objects, lighted candles).
Where the MAINS plug or an appliance coupler is used as
the disconnect device, the disconnect device shall remain
readily operable.

Know these safety symbols

Note
•• The type plate is located on the bottom of the product.

This ‘bolt of lightning’ indicates uninsulated material within your unit
may cause an electrical shock. For the safety of everyone in your
household, please do not remove product covering.
The ‘exclamation point’ calls attention to features for which you
should read the enclosed literature closely to prevent operating and
maintenance problems.
WARNING: To reduce the risk of fire or electric shock, this
apparatus should not be exposed to rain or moisture and objects
filled with liquids, such as vases, should not be placed on this
apparatus.
CAUTION: To prevent electric shock, match wide blade of plug to
wide slot, fully insert.

Quick start guide

2	 Notice
Any changes or modifications made to this device that are not
expressly approved by Gibson Innovations may void the user’s
authority to operate the equipment.
 
Disposal of your old product

Your product is designed and manufactured with high quality
materials and components, which can be recycled and reused.

Warning
••
••
••
••
••

•	
•	
•	
•	
•	
•	
•	
•	

•	

Specifications are subject to change without notice.
This product has been manufactured by, and is sold under the responsibility of Gibson
Innovations Ltd., and Gibson Innovations Ltd. is the warrantor in relation to this product.
Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V.
and are used under license.

•	

AJ3232_79_QSG_V2.0

Never remove the casing of this radio.
Never lubricate any part of this radio.
Never place this radio on other electrical equipment.
Keep this radio away from direct sunlight, naked flames or heat.
Make sure that you always have easy access to the power cord, plug or
adapter to disconnect the radio from the power.

Read these instructions.
Follow all instructions.
Do not use this product near water.
Clean only with dry cloth.
Do not block any ventilation openings. Install in accordance
with the manufacturer’s instructions.
Only use attachments or accessories specified by the
manufacturer.
Unplug this product during lightning storms or when unused
for long periods of time.
Refer all servicing to qualified service personnel. Servicing is
required when the product has been damaged in any way,
such as liquid has been spilled or objects have fallen into the
product, the product has been exposed to rain or moisture,
does not operate normally, or has been dropped.
Battery usage CAUTION – To prevent battery leakage which
may result in bodily injury, property damage, or damage to
the product:
•	 Install all batteries correctly, + and - as marked on the
product.
•	 Do not mix batteries (old and new or carbon and
alkaline, etc.).
•	 Remove batteries when the product is not used for a
long time.
Batteries shall not be exposed to excessive heat such as
sunshine, fire or the like.

This symbol on a product means that the product is covered by
European Directive 2012/19/EU. Inform yourself about the local
separate collection system for electrical and electronic products.
Follow local rules and never dispose of the product with normal
household waste. Correct disposal of old products helps prevent
negative consequences for the environment and human health.
 
Environmental information
All unnecessary packaging has been omitted. We have tried to
make the packaging easy to separate into three materials: cardboard
(box), polystyrene foam (buffer) and polyethylene (bags, protective
foam sheet.)
Your system consists of materials which can be recycled and reused
if disassembled by a specialized company. Please observe the local
regulations regarding the disposal of packaging materials, exhausted
batteries and old equipment.

Warranty against Defects
In this warranty:
We or us means Gibson Innovations ABN 531 651 059 75, and our contact details are set out at the end of this
warranty;
You means the purchaser or the original end-user of the Goods;
Supplier means the authorised distributor or retailer of the Goods that sold you the Goods in Australia or New
Zealand; and
Goods means the product or equipment which was accompanied by this warranty and purchased in Australia or New
Zealand.
If you require assistance with the operation of the product, its features or specifications please call the Philips
Consumer Care Centre on 1300 850 633 in Australia or 0800 639 953 in New Zealand.

2xAAA

Australia: Our Goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are
entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss
or damage. You are also entitled to have the Goods repaired or replaced if the goods fail to be of acceptable quality
and the failure does not amount to a major failure. This is not a complete statement of your legal rights as a consumer.
New Zealand: Our Goods come with guarantees that cannot be excluded under the Consumer Guarantees Act 1993.
This guarantee applies in addition to the conditions and guarantees implied by that legislation.
Additional Warranty:
In addition to the rights and remedies that you have under the Australian Consumer Law, Consumer Guarantees Act
of New Zealand or any other applicable law, we provide the following warranty against defects:

Note: The batteries (not supplied) can only back up clock and alarm
settings when AC power is disconnected.

1. If, during the first 12 months from their date of purchase from the Supplier (Warranty Period), the Goods prove
defective by reason of improper workmanship or materials and none of your statutory rights or remedies apply, we
will repair or replace the Goods without charge.
2. We do not have to repair or replace the Goods under this Additional Warranty if the Goods have been used for a
commercial purpose; misused, improperly or inappropriately installed, operated or repaired; abused; damaged; or
not maintained in accordance with the manufacturer’s instructions.
3. Even when we do not have to repair or replace the Goods, we may decide to do so anyway. In some cases, we
may decide to substitute the Goods with a similar alternative product of our choosing. All such decisions are at
our absolute discretion.
4. All such repaired, replaced or substituted Goods continue to receive the benefit of this Additional Warranty for the
time remaining on the original Warranty Period.
5. This Additional Warranty is limited to repair, replacement or substitution only. As far as the law permits, we will not
be liable for any loss or damage caused to property or persons arising from any cause whatsoever.
6. In order to claim under this Additional Warranty you must telephone us on 1300 850 633 in Australia or 0800 639
953 in New Zealand within the Warranty Period. You will be asked for details of the Goods, a description of the
defect and your personal details. Upon accepting your claim, we shall assist you with either returning the Goods to
the Supplier for replacement or to the most convenient Philips Authorised Service Centre for your Goods to be
repaired. In some case we may require that you return to the Goods to us (at the address below) for repair,
replacement or substitution.

Set clock

 All returned Goods must be accompanied by satisfactory proof of purchase which clearly indicates the name and
address of the Supplier, the date and place of purchase and identifies product. It is best to provide a legible and
unmodified receipt or sales invoice.
 You must bear any expense for return of the Goods or otherwise associated with making your claim under this
Additional Warranty.
7. This warranty is only valid and enforceable in Australia and New Zealand.
Contact us or the place of purchase for further details.
Australia
Gibson Innovations
305/4 Columbia Court,
Baulkham Hills, NSW, 2153

•• Press to select FM or MW radio.
•• Press and hold for 2 seconds to switch to standby mode.

Consumer Care: 1300 850 633
E-mail: PhilipsSound_APAC@gibson.com
Website: www.philips.com/support

New Zealand

Consumer Care: 0800 639 953
Email: PhilipsSound_APAC@gibson.com
Website: www.philips.com/support

Note: Make sure that the product is in standby mode.
May 2016

AJ3232_79_QSG_V2.0.indd 1

6/6/2017 4:11:15 PM

Press AL1 or AL2 reepeatedly to activate or deactivate
the alarm timer.
»» If the alarm timer is activated, the alarm indicator
for the radio or buzzer is displayed.

Set alarm

»» If the alarm timer is deactivated, the alarm indicator
disappears.

•	

To stop the alarm, press the corresponding AL1
or AL2.

»» The alarm repeats ringing for the next day.
Note: When the alarm sounds, volume increases
gradually to the maximum alarm volume. You cannot
adjust the alarm volume manually.

When the alarm sounds, press SNOOZE.

»» The alarm snoozes and repeats ringing nine minutes later.

Note:
•• You can only set the alarm in standby mode.
•• Make sure that you have set the clock correctly.

Tune to FM/MW radio stations
Select FM/MW radio

Prepare radio antenna

Store FM/MW radio stations automatically

Tip: For better reception, fully extend and adjust the
position of the antenna.

Store FM/MW radio stations manually
Select a preset radio station

1	
2	
3	

Select FM or MW radio.

4	
5	
6	

Press - TUNING + to select a number.

Tune to a radio station.
Press and hold PRESET for two seconds.
»» The preset number begins to blink.
Press PRESET again to confirm.
Repeat steps 2 to 5 to store other stations.

Note:
•	 You can store a maximum of 20 FM radio
stations and 20 MW radio stations.
•	 To overwrite a pre-stored radio station, store
another one with its sequence number.

X20

Specifications
Amplifier
Rated Output Power

0.4 W RMS

Tuner

Press SLEEP repeatedly to select a time period (in minutes).
»» The product switches to standby mode automatically
after the preset period.
»» When [OFF] is displayed, the sleep timer is deactivated.

FM: 87.5-108 MHz;
MW: 531-1602 KHz

Tuning Grid

FM: 50 KHz;
MW: 9 KHz

Number of presets

FM: 20;
MW: 20

General information

To download the full user manual,
visit www.philips.com/support.

AJ3232_79_QSG_V2.0.indd 2

Tuning Range

AC power

220-240V~ 50/60Hz

Operation Power
Consumption

8W

Standby Power Consumption

<1 W

Dimensions:
- Main Unit (W x H x D)

190 x 94 x 62 mm

Weight: - Main Unit

0.55 kg

6/6/2017 4:11:17 PM



Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : Yes
Language                        : en-US
Page Count                      : 2
EXIF Metadata provided by EXIF.tools

Navigation menu