Phoenix Contact and KG SXPCEAN2 PCI Express Half mini card WLAN module User Manual
Phoenix Contact GmbH & Co. KG PCI Express Half mini card WLAN module
Contents
User Manual
2018-08-27
USER MANUAL_SXPCEAN2_REV00.DOCX
1 / 4
Version: 00
Author: M.Hemp
Date: 2018-08-27
User Manual
1 Identification
This user manual refers to wlan module SX-PCEAN2 with the following certification information:
FCC ID
YG3-SXPCEAN2
IC-Nr
4720B-SXPCEAN2
HVIN (Hardware Version Identification Number)
SX-PCEAN2
FVIN (Firmware Version Identification Number)
1.0.3.0.2
PMN (Product Marketing Name)
SX-PCEAN2
2 Statement
Since this module is not sold to general end users directly, there is no user manual that describes
functionality of the module without its implementation into a host system.
For the details regarding the stand-alone module, please refer to the specification sheet.
This module should be installed in the host device according to the interface specification
(installation procedure).
2018-08-27
USER MANUAL_SXPCEAN2_REV00.DOCX
2 / 4
Version: 00
Author: M.Hemp
Date: 2018-08-27
3 Certified Antennas
Only the following certified antennas may be used with the module:
Antenna
Manufacturer
Frequency band [GHz]
Gain [dBi]
RAD-ISM-2400-ANT-VAN-3-0-RSMA 2
Phoenix Contact
2.4
3
RAD-ISM-2400-ANT-OMNI-2-1-RSMA 2
Phoenix Contact
2.4
2.1
RAD-ISM-2400-ANT-OMNI-6-0 2
Phoenix Contact
2.4
6
ANT-OMNI-5900-01 2
Phoenix Contact
5
5
2JZ0102 (omnidirectional radiator) 2
2J antennae
2.4
2
5
2
2JZ0102 (directional radiator) 2
2J antennae
2.4
5
5
5
H2B1PC1A1C
Unictron Technologies
Corporation
2.4
1.8
5
3.9
ANT-OMNI-2459-02 2
Phoenix Contact
2.4
2.5
5
5
ANT-DIR-2459-01 1 2
Phoenix Contact
2.4
9
5
9
(1) Note:
Use of antenna ANT-DIR-2459-01 is only allowed in single chain operation on antenna chain 0!
(2) Note:
All marked antennas must be used on non-DFS channels only!
2018-08-27
USER MANUAL_SXPCEAN2_REV00.DOCX
3 / 4
Version: 00
Author: M.Hemp
Date: 2018-08-27
4 Information for implementation
4.1 Information on the host device
The following information must be indicated on the host device of this module
4.1.1 For FCC
Contains Transmitter Module FCC ID: YG3-SXPCEAN2
or
Contains FCC ID: YG3-SXPCEAN2
4.1.2 For IC
Contains Transmitter Module IC: 4720B-SXPCEAN2
or
Contains IC: 4720B-SXPCEAN2
4.1.3 For FCC and IC
The following statements must be described in the user manual of the host device of this
module
This device complies with Part 15 of FCC Rules and Industry Canada’s
licence-exempt RSSs. Operation is subject to the following two
conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that
may cause undesired operation of the device.
Le présent appareil est conforme à la partie 15 des règles de la FCC et
aux normes des CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'appareil doit accepter tout brouillage subi, même si le brouillage
est susceptible d'en compromettre le fonctionnement.
If it is difficult to describe this statement on the host product due to the size, please describe in
the user manual.
2018-08-27
USER MANUAL_SXPCEAN2_REV00.DOCX
4 / 4
Version: 00
Author: M.Hemp
Date: 2018-08-27
4.2 Information in the user manual
4.2.1 For FCC
FCC CAUTION
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate
the equipment.
This transmitter must not be co-located or operated in conjunction with
any other antenna or transmitter.
4.2.2 For IC
5150-5250MHz and 5250-5350MHz bands are restricted to indoor
operations only.
La bandes 5150-5250MHz et 5250-5350MHz ont restreints à une
utilisation à l’intérieur seulement.
High-power radars are allocated as primary users (i.e. priority users) of
the bands 5250-5350 MHz and 5650-5850 MHz and that these radars
could cause interference and/or damage to LE-LAN devices.
Les radars de haute puissance sont désignés utilisateurs principaux (c.-
à-d., qu'ils ont la priorité) pour les bandes 5250-5350 MHz et 5650-5850
MHz, et ces radars pourraient causer du brouillage et/ou des
dommages aux dispositifs LAN-EL.
4.2.3 For FCC and IC
This equipment complies with FCC/IC radiation exposure limits set forth
for an uncontrolled environment and meets the FCC radio frequency
(RF) Exposure Guidelines and RSS-102 of the IC radio frequency (RF)
Exposure rules. This equipment should be installed and operated
keeping the radiator at least 20cm or more away from person’s body.
Cet équipement est conforme aux limites d’exposition aux
rayonnements énoncées pour un environnement non contrôlé et
respecte les règles les radioélectriques (RF) de la FCC lignes directrices
d'exposition et d’exposition aux fréquences radioélectriques (RF) CNR-
102 de l’IC. Cet équipement doit être installé et utilisé en gardant une
distance de 20 cm ou plus entre le radiateur et le corps humain.