Pimax Technology P2 Pimax 8K User Manual
Pimax Technology(Shanghai)Co., Ltd. Pimax 8K Users Manual
Contents
- 1. User Manual
- 2. User Manual Rev
User Manual Rev
Pimax VR
Step 1, Download Pi Tool from
www.pimaxvr.com and install,
Step 2, Connect Pimax 8K to PC
To get detail instruction,
please follow online guide to set up：
https://www.pimaxvr.com/en/8k_setup
Product Name：
Weight：
Dimensions:
Lens:
Screen Resolution:
Keys:
Audio Interface:
Sensors:
Interface:
OS：
CPU：
GPU:
Ram:
Output:
Pimax VR
470g
280.01*108.2*135.9 mm
Fresnel lens, FOV 200°,
IPD 55-75mm.
8K 3840*2160*2
Power Key, Volume Keys
3.5mm Audio jack x 1
Gyroscope，Magnetometer，
Acceleration，Light Sensor.
DP1.4, USB 2.0/3.0
Windows 7 SP1/Windows 10 64bit or later
Intel Core i5 or equivalent or later
NVIDIA GTX1070 or later
8GB or bigger
DP1.4，USB2.0/3.0
Download Pi Tool from www.pimaxvr.com and install
If you see the Pi Tool interface, it means the VR
is connected to PC correctly and recognized by Pi Tool.
Check whether Pimax 8K VR is connected to PC correctly.
Data cable assembly Bands assembly
Product Specification
3.1 Install Pi Tool software
3.2 Connect to computer
Open Pi Tool when the internet access is available.
Pi Tool will check the firmware version, and remind
you if the firmware need to be updated.
Recommended configuration：
Attention: Please DO NOT disconnect your USB cable
or close your PC when you are updating the firmware.
FCC Statement
Any Changes or modifications not expressly approved by the
party responsible for compliance could void the user’s
authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired operation.
Official website：http://www.pimaxvr.com
Official Forum：http://forum.pimaxvr.com
Email：support@pimaxvr.com
Pull out the USB plug to cut off the power supply to VR.
During using the VR, long press power key， The VR will be shut down
and enter standby mode.
Cabling:
1Power key
7IPD Adjustment
Type_c4 5
Headphone jack6
2Volume keys
3Strap
DP DP HDMI HDMI
HDMI
2
3
4
1
7
6
5
*The headset can be connected with controllers
through 2.4G wireless communication