Pismolabs Technology P1121 WLAN 802.11b/g/n module User Manual N21 U8G P1121

Pismo Labs Technology Limited WLAN 802.11b/g/n module N21 U8G P1121

Contents

User manual-REV2

IMPORTANT NOTE:FCC Radiation Exposure Statement:This module complies with FCC radiation exposure limits set forth for an uncontrolledenvironment. This equipment should be installed and operated with minimum distance 20cm between the antenna & the user and transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.OrThis module should be installed and operated with minimum distance 35cm between the antenna & user when this transmitter can co-located with additional one WiFi module (FCC ID:U8G-P1121) and two LTE modules (FCC ID:N7NMC7355).This device is intended only for OEM integrators under the following conditions:1)The antenna must be installed such that 20 cm is maintained between the antenna and users, and the transmitter module may not be co-located with any other transmitter or antenna,2)The antenna must be installed such that 35 cm is maintained between the antenna and users, and transmitter can co-located with additional one WiFi module (FCC ID:U8G-P1121) and two LTE modules (FCC ID:N7NMC7355), (remark: other installation requirement of LTE module (FCC ID:N7MC7355) must follow its installation guidance)3)For all products market in US, OEM has to limit the operation channels in CH1 to CH11 for 2.4G band by supplied firmware programming tool. OEM shall not supply any tool or info to the end-user regarding to Regulatory Domain change.As long as 3 conditions above are met, further transmitter test will not be required. However,the OEM integrator is still responsible for testing their end-product for any additionalcompliance requirements required with this module installedIMPORTANT NOTE: In the event that these conditions can not be met (for example certain laptop configurations or co-location with another transmitter), then the FCC authorization is no longer considered valid and the FCC ID can not be used on the final product. In these circumstances, the OEM integrator will be responsible for re-evaluating the end product (including the transmitter) and obtaining a separate FCC authorization.End Product LabelingIf the module is used stand-alone and not co-located with other transmitter(s), the final end product must be labeled in a visible area with the following: “Contains FCC ID: U8G-P1121”orIf the module is used co-located with additional WiFI module(FCC ID:U8G-P1121) and two LTE modules (FCC ID N7NMC7355), the final end product must be labeled in a visible area with the following: (remark: other installation requirement of LTE module (FCC ID:N7MC7355) must follow its installation guidance)“Contain FCC ID: U8GP1121”“Contain FCC ID: N7NMC7355”
Manual Information To the End UserThe OEM integrator has to be aware not to provide information to the end user regarding how to install or remove this RF module in the user’s manual of the end product which integrates this module.The end user manual shall include all required regulatory information/warning and the minimum installation distance between the end product and the user as show in this manual.

Navigation menu