Planet Toys Worldwide 3037R49 RC Motor Cycle User Manual

Planet Toys Worldwide Limited RC Motor Cycle

User Manual

Download: Planet Toys Worldwide 3037R49 RC Motor Cycle User Manual
Mirror Download [FCC.gov]Planet Toys Worldwide 3037R49 RC Motor Cycle User Manual
Document ID337682
Application IDtYjt6ZzZtJQt3tqBfbUjHQ==
Document DescriptionUser Manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize6.25kB (78100 bits)
Date Submitted2003-07-07 00:00:00
Date Available2003-07-07 00:00:00
Creation Date2003-05-26 16:02:45
Document Lastmod2003-05-26 16:13:55
Document TitleUser Manual
Document CreatorHP 9100C Digital Sender
Document Author: ITS ELECTRIC TOY

#3037 MINI RC MOTORCYCLE
START UP
I. Press the release button and REMOVE the clear DOME cover.
2. CAREFULLY LIFT OFF the PLASTIC blister. CAREFULLY unscrew AND
REMOVE the vehicle from the PLASTIC blister.
3.Unscrew and REMOVE the battery COVERS on both the controller and THE charging
unit. INSERT 3 “AA" batteries (not included) into charger unit and 3 “AAA” batteries
(not included) into controller of the battery compartments Then REPLACE the battery
COVERS and tighten the screws.
CHARGING THE VEHICLE
I Place the vehicle on TOP OF the charging unit HOLDER, GENTLY BUT FIRMLY
PUSH THE VEHICLE INTO POSITION ON THE HOLDER.
2.Press the charging button and the charging LED indicator will turn on INDICATING
THE VHICLE IS CHARGING. The LED indicator will automatically go off when the
vehicle is fully charged (approx. 45 seconds).
PLEASE NOTE: a). If the batteries inside the controller are low. the LED
light will become dim or NOT LIGHT UPAT ALL, AND YOU WILL NOT
BE ABLE TO CHARGE THE VEHICLE. PLEASE REPLACE THE
BATTERIES.
b). Make sure the BATTERIES HAVE BEEN INSERTED
CORRECTLY (+ OR - ) then preparing TO CHARGE THE VEHICLE
c). Rechargeable batteries may get hot and dangerous if being continuously
recharged.
OPERATING THE VEHICLE:
1).FuIIy extend the CONTROLLER ANTENNA.
2).Press the forward and reverse buttons to make the vehicle move FORWARDS AND
BACKWARDS. FOR LEFT AND RIGHT TURNING, press the lefi and right buttons
respectively. PLEASE NOTE, the vehicle will turn only when it is moving forwards or
backwards. ALSO NOTE, the operation light will turn on when the vehicle is in use.
3).Adjust the fine tune STEERING LEVER located under the vehicle to keep it moving
straight.
PLEASE NOTE: a)When operating the controller, please do not touch the antenna. As
control distance and the speed will both be AFFECTED.
b).lf YOU NOTICE A REDUCTION IN SPEED AND CONTROL, PLEASE
BEGIN RE-CHARGING PER THE INSTRUCTIONS ABOVE.
WARNING: Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Pan 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
0 Reorient or relocate the receiving antenna
0 Increase the separation between the equipment and receiver
0 Connect the equipment into an outlet on a circuit different from that to which
the receiver is needed
0 Consult the dealer or an experienced radio/I‘ V technician for help
This device complies with Part 15 of the FCC Rules‘ Operation is subject to the
following two conditions:
(I) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation of the device

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.2
Linearized                      : No
Creator                         : HP 9100C Digital Sender
Create Date                     : 2003:05:26 16:02:45
Author                          : ITS ELECTRIC TOY
Producer                        : 
Title                           : 
Subject                         : 
Modify Date                     : 2003:05:26 16:13:55+08:00
Page Count                      : 2
EXIF Metadata provided by EXIF.tools
FCC ID Filing: QG33037R49

Navigation menu