Planet Toys Worldwide 3116R49 Remote Controlled Toy User Manual

Download:
Mirror Download [FCC.gov]
Document ID	326374
Application ID	R/bWbGFiG+5oZWIIsjp8kQ==
Document Description	User Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	9.05kB (113148 bits)
Date Submitted	2003-05-19 00:00:00
Date Available	2003-05-19 00:00:00
Creation Date	2003-05-10 11:51:44
Document Lastmod	2003-05-10 12:07:35
Document Title	User Manual
Document Creator	HP 9100C Digital Sender
Document Author:	ITS ELECTRIC TOY

START UP
I. Carefully lifi offthe plastic blister and unscrew and remove the TANK.
2. Unscrew and remove the battery covers on both the controller and the
charging unit. Insert 4 "AA" batteries (not included) into the charger
unit and 3 "AAA" batteries (not included) into controller unit. Then replace
the batteries cover and tighten the screws. CHARGING THE TANK.
1. Place the TANK on top ofthe charging unit in the direction ofthe TANK
outline as shown. Gently but firmly push the TANK into position on the
unit.
2. Press the charging button.
The charging light indicator
will turn on indicating the TANK
is charging. The light indicator
will turn offwhen the TANK is
fully charged — approx. 45 seconds
3. To remove TANK from unit, gently
but firmly push down on the front
and Iifi off
* ONLY REMOVE THE TANK FROM
THE CHARGING UNIT GENTLY. REMOVING OTHERWISE
MAY CAUSE DAMAGE TO THE
CHARGING UNIT!
PLEASE NOTE:
a). If the batteries inside the charger are low, the charging light will become
dim or not light up at all, and you will not be able to charge the vehicle.
Please replace the batteries.
b). Make sure the batteries have been inserted correctly (+ or - ) then
prepare to charge the vehicle.
c). Rechargeable batteries may get hot and dangerous if being continuously
recharged.
cl). Ifcharger light dims or ifvehicle does not respond properly, please
replace charger and/or controller batteries.
OPERATING THE VEHICLE
I. Fully extend the controller antenna
2. STEERING FORWARD - FOR STRAIGHT FORWARD MOTION, PRESS THE
LEFT HAND SIDE FORWARD( F ) BUTTONS.
TO MAKE "HE TANK TURN FORWARD RIGHT. PRESS THE LEFT HAND
SIDE FORWARDt F ) BUTTON AND THE RIGHT HAND SIDE( R)
BUTTON.
TO MAKE THE TANK TURN FORWARD LEFT PRESS THE RIGHT HAND
SIDE FORWARD( F) BUTTON AND THE MIDDLE LEFT( L) BUTTON.
3 STEERING REVERSE - FOR STRAIGHT REVERSE MOTION, PRESS
LEFT I (AND SIDE ,VERSE ( R ) BUTTONS
TO MAKE THE TANK TURN REVERSE RIGI IT PRESSING TIIE LEFT HAND
SIDE REVERSE BUTTON AND RIGHT HAND SIDE ( R ) BUTTON
TO MAKE THE TANK TURN REVERSE LEFT PRESSING THE RIGHT HAND
SIDE REVFERSF,( R ) BUTTON AND THE MIDDLE LEFT( L) BUTTONA
PLEASE NOTE, the TANK will turn only when it is moving forwards or backwards.
ITEM NO. 3116 - TANKS
a). When operating the controller, please do not touch the antenna.
As control distance and the speed will both be affected
b). Ifyou notice a reduction in speed and control, please begin re-charging
per the instructions above, or if necessary replace batteries.
PLEASE NOTE:
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part I5 ofthe FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
0 Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver
~ Connect the equipment into an outlet on a circuit different from that to
which the receiver is needed
- Consult the dealer or an experienced radio/TV technician for help
NOTE:
0 Do not mix old and new batteries
- Do not mix alkaline, standard (carbon zinc). or rechargeable
(nickel—cadmium) batteries.
WARNING:
Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user‘s authority to operate the
equipment.
This device complies with pan I5 ofthe FCC rules. Operation is subject to
the following two conditions:
I. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference
that may cause undesired operation ofthe device.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE
FOR ANY RADIO OR TV INTERFERENCE CAUSED BY
UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT.
SUCH MODIFICATIONS COULD VOID THE USER'S
AUTHORITY TO OPERATE THE EQUIPMENT,*IMPORTANT » lF CHARGER
LIGHT DIMS OR lF VEHICLE
DOES NOT RESPOND PROPERLY, PLEASE REPLACE
CHARGER BATTERIES (4x AA)r
CONSUMER SERVICE:
Please do not return to store!
For parts information, or questions please call:
l-877-FUN-TOYS
Manufactured and distributed by
Planet Toys, Sarwota, FL 34242
Made in China
Colors and contents may vary
Keep content details for future reference INSTRUCTION MANUAL

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.2
Linearized                      : No
Creator                         : HP 9100C Digital Sender
Create Date                     : 2003:05:10 11:51:44
Author                          : ITS ELECTRIC TOY
Producer                        : 
Title                           : 
Subject                         : 
Modify Date                     : 2003:05:10 12:07:35+08:00
Page Count                      : 4

EXIF Metadata provided by EXIF.tools