Planet Toys Worldwide 3282T27 26.96-27.28 MHz WIRELESS R/CTX User Manual USERS MANUAL
Planet Toys Worldwide Limited 26.96-27.28 MHz WIRELESS R/CTX USERS MANUAL
USERS MANUAL
PLEASE NOTE: This equipment has been tested and found to comply with the limits for a Class 8 digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception. which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measuresr - Reorient or relocate the receiving antenna - Increase the separation between the equipment and receiver - Connect the equipment into an outlet on a circurt different from that to which the receiver is needed - Consult the dealer or an experienced radio/TV technician for help NOTE: — Do not mix old and new batteries - Do not mix alkaline, standard (carbon zinc), or rechargeable (nickel-cadmium) batteries. INSTRUCTION MANUAL ITEM NO. 1mm“ um um“ coon alum '- Manulatzlured and (IISITIIMIIVII try l’lanel Toys. Sarasota. FL Jet/Al? Made. III CIlllld ,Cnli>r~; and contents may vary Kenn mntent details for lutnm referent»: TM & k: Hannaflurham (sins) *IMPORTANT - IF CHARGER LIGHT DIMS OR IF VEHICLE DOES NOT RESPOND PROPERLY, PLEASE REPLACE CHARGER BATTERIES (4x AA). ”NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER'S AUTHORITY TO OPERATE THE EQUIPMENT. WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference recieved. including interference that may cause undesired operation of the device. CONSUMER SERVICE Please do not return to store! For parts information, or questions please call: 1-877-FU N-TOYS 8/22103 Model No. : FCC ID: QG33282T27 Planet Toys Worldwide Ltd. I l07 Chinachem Golden Plaza. Phone: (852) 23] 1 8697 77 Mody Road, Fax: (852) 231] 7711 Tsimshalsui East Kowloon , Hong Kong POWER OF ATTORNEY DATE: 9 th Dec.,2003. Federal Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 To Whom It May Concern: We, the undersigned, hereby authorize TIMCO ENGINEERING, INC. on our behalf, to apply to the Federal Communications Commission on our equipment. Any and all acts carried out by TIMCO ENGINEERING. INC. on our behalf shall have the same effect as acts of our own. This authorization expires on 9th, March, 2004. This is to advise that we are in full compliance with the Anti- Drug Abuse Act. We, Planet Toys Worldwide Ltd., are not subject to a denial of federal benefits pursuant to Section 5301 of the Anti—Drug Act of 1988, 21 USC853a, and no party to the application is subject to a denial of federal benefits pursuant to that section. Sincerely, Planet Toys Worldwide Ltd. T.K. Wong / Planet Toys Worldwide Ltd. Merchandise Manager MANUFACTURER: Root Land Plastic & Electronic Products Co. Ltd. Bai Yun Keng Industrial Area, Tu—Hu, Danshui Town of Hui Yang City, China. START UP 1. Carefully lift off the plastic blister and unscrew and remove the vehicle. 2. Unscrew and remove the battery covers on both the controller and the charging unit. Insert 3 ““AA batteries (not included) into the charger unit and 3 'AAA" batteries (not included) into controller unit. Then replace the batteries cover and tighten the screws CHARGING THE VEHICLE 1. Place the vehicle on top of the charging unit in the direction of the vehicle outline as shown. Gently but firmly push the vehicle into position on the unit. 2. Press the charging button, the charging light indicator will turn on indicating that the vehicle is charging. The light indicator will turn off when the vehicle is fully charged approx. 45 seconds 3. To remove vehicle from unit. gently but firmly push down on the front and lift off. " ONLY REMOVE THE VEHICLE FROM THE CHARGING UNIT GENTLY. REMOVING OTHERWISE MAY CAUSE DAMAGE TO THE CHARGING UNIT. PLEASE NOTE: a). If the batteries inside the charger are low, the LED light will become dim or not light up at all, and you will not be able to charge the vehicle. Please replace the batteries. b). Make sure the batteries have been inserted correctly (+ or -) then prepare to charge the vehicle. c). Rechargeable batteries may get hot and dangerous if being continuously recharged. d). If the vehicle does not respond properly, please replace charger and/or controller batteries. OPERATING THE VEHICLE 1. Fully extend the controller antenna. 2. Press the forward and reverse buttons (F or R) to make the vehicle move forwards and backwards. For left and right turning, press the left and right buttons (L or R) respectively. Please note, the vehicle will turn only when it is moving towards or backwards 3. Hold controller and antenna high for best reception and control. 4. Adjust the fine tune steering lever located under the vehicle to keep it moving straight PLEASE NOTE: a). When operating the controller. please do not touch the antenna. As control distance and the speed will both be affected. b). If you notice a reduction in speed and control, please begin recharging per the instructions above.
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.3 Linearized : No Creator : Adobe Photoshop Elements 2.0 Create Date : 2003:12:10 12:36:37+08:00 Producer : Adobe Photoshop Elements for Windows X Resolution : 72 Y Resolution : 72 Orientation : Horizontal (normal) Resolution Unit : inches Software : Adobe Photoshop Elements 2.0 Modify Date : 2003:12:10 12:36:37 Color Space : Uncalibrated Exif Image Width : 1600 Exif Image Height : 1038 Compression : JPEG (old-style) Thumbnail Offset : 302 Thumbnail Length : 0 Photoshop Thumbnail : (Binary data 2498 bytes, use -b option to extract) Warning : IFD0 pointer references previous IFD0 directory Application Record Version : 2 IPTC Digest : 460cf28926b856dab09c01a1b0a79077 Displayed Units X : inches Displayed Units Y : inches Print Style : Centered Print Position : 0 0 Print Scale : 1 Global Angle : 30 Global Altitude : 30 Copyright Flag : False URL List : Slices Group Name : QG33282T27_InstructionManual2 Num Slices : 1 Has Real Merged Data : Yes Writer Name : Adobe Photoshop Elements Reader Name : Adobe Photoshop Elements 2.0 Exif Byte Order : Big-endian (Motorola, MM) Page Count : 3 XMP Toolkit : XMP toolkit 2.8.2-33, framework 1.5 About : uuid:70ec2a51-2aca-11d8-8420-e0961c68b643 Creator Tool : Adobe Photoshop Elements for Windows, version 2.0 Document ID : adobe:docid:photoshop:2ad57eba-2aca-11d8-8420-e0961c68b643EXIF Metadata provided by EXIF.tools