Planet Toys Worldwide 3290T27 RC Car User Manual

Download:
Mirror Download [FCC.gov]
Document ID	381273
Application ID	z9TTMSC9uZrl3YFveWJ47Q==
Document Description	User Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	6.48kB (80942 bits)
Date Submitted	2003-12-15 00:00:00
Date Available	2003-12-15 00:00:00
Creation Date	2003-12-01 17:31:46
Document Lastmod	0000-00-00 00:00:00
Document Title	User Manual
Document Creator	HP 9100C Digital Sender
Document Author:	ITS ELECTRIC TOY

#3290 MINI RC MONSTER GARAGE
START UP
1. CAREFULLY LIFT OFF the PLASTIC blister and unscrew and remove the vehicle
from the plastic blisterl
2. Unscrew and REMOVE the battery COVERS on both the controller and THE charging
unit. INSERT 4 “AA” batteries (not included) into charger unit and 3 “AAA” batteries
(not included) into controller of the battery compartments. Then REPLACE the battery
COVERS and tighten the screws.
CHARGING THE VEHICLE
1. Insert the charger plug into the charging receptacle located on the bottom of vehicle
24 Press the charging button and the charging LED indicator will turn on INDICATING
THE VEHICLE IS CHARGING. The LED indicator will automatically go off when
the vehicle is fully charged (approx. 45 seconds).
PLEASE NOTE: 8). lfthe batteries inside the controller are low, the LED light will
become dim or NOT LIGHT UP AT ALL, AND YOU WILL NOT BE ABLE TO
CHARGE THE VEHlCLE. PLEASE REPLACE THE BATTERIES,
b). Make sure the BATTERIES HAVE BEEN mSERTED
CORRECTLY (+ OR - ) then preparing TO CHARGE THE VEHICLE.
c). Rechargeable batteries may get hot and dangerous if being continuously
recharged.
OPERATING THE VEHICLE:
l).0pen the mask of the controller.
2)lPress the forward and reverse steering handle bar to make the vehicle move
FORWARDS AND BACKWARDS. FOR LEFT AND RIGHT TURNING. pull the
steering handle bar respectively. PLEASE NOTE, the vehicle will turn only when it is
moving forwards or backwards,
3) Press the button of the nose, the vehicle’s movement functional will be showed.
PLEASE NOTE: a) When operating the controller. please do not touch the mask As
the control distance and the speed will both be AFFECTED
b).lfYOU NOTICE A REDUCTION IN SPEED AND CONTROL, PLEASE
BEGIN RECHARGING PER THE INSTRUCTIONS ABOVE.
WARNING: Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. if this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more ofthe following
measures:
- Reorient or relocate the receiving antenna
0 Increase the separation between the equipment and receiver
0 Connect the equipment into an outlet on a circuit different from that to which
the receiver is needed
0 Consult the dealer or an experienced radio/TV technician for help
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation of the device

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.2
Linearized                      : No
Page Count                      : 2
Creator                         : HP 9100C Digital Sender
Create Date                     : 2003:12:01 17:31:46
Author                          : ITS ELECTRIC TOY
Producer                        : 
Title                           : 
Subject                         : manual

EXIF Metadata provided by EXIF.tools