Planet Toys Worldwide 3300 RC Car User Manual User Diagram

Download:
Mirror Download [FCC.gov]
Document ID	279816
Application ID	1E6tmG/3dpUluvpsnAob+w==
Document Description	User Diagram
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	15.89kB (198642 bits)
Date Submitted	2002-10-30 00:00:00
Date Available	2002-10-30 00:00:00
Creation Date	0000-00-00 00:00:00
Producing Software	HP Digital Sending Device
Document Lastmod	2002-10-10 11:51:34
Document Title	User Diagram
Document Creator	HP Digital Sending Device

START UP
1. Press the release button and remove the clear dome cover.
2. Carefully lift off the plastic blister securing the charging unit and antenna.
and remove both. Carefully unscrew and remove the vehicle from the
plastic blister.
3. Secure / thread the antenna in the antenna hole located on the controller
(see diagram #1). The antenna is a “unique coupling" and the antenna
connection a unique connection.
4. Unscrew and remove the battery covers on both the controller and the
charging unit. Insert 3 “AAA" batteries (not included) into the charger
unit and 3 "AA" batteries (not included) into controller unit. Then replace
the battery covers and tighten the screws (see diagram #2).
.. Diagram #2
Diagram #1 t '
F‘T‘ ”‘ E ‘
, ‘f’fi
Antenna hole .
located on controller chem,
CHARGING THE VEHICLE
1 Place the vehicle on top of the
charging unit in the direction of
the arrow as shown. Gently but
firmly push the vehicle into
position on the unit
(see diagram its).
2. Press the charging button. The
charging LED indicatorwill turn
on indicating the vehicle is
charging. The LED indicator will
turn off when the vehicle is fully
charged — approx. 45 seconds.
Charger Lighl Charger Button
3. To remove vehicle from unit, gently but firmly
push down on the front and lift off
(see diagram M).
" ONLY REMOVE THE VEHICLE FROM
THE CHARGING UNIT AS SHOWN IN
DIAGRAM #4. REMOVING OTHERWISE
MAY CAUSE DAMAGE TO THE
CHARGING UNITI
PLEASE NOTE:
3). If the batteries inside the controller are low, the LED light will become
dim or not light up at all, and you will not be able to charge the vehicle.
Please replace the batteries.
by Make sure the batteries have been inserted correctly (+ or - ) then
prepare to charge the vehicle.
0). Rechargeable batteries may get hot and dangerous if being continuously
recharged.
d). If charger light dims or if vehicle does not respond property. please
replace charger batteries (3x AAA).
OPERATING THE VEHICLE
1. Fully extend the controller antenna.
2. Press the forward and reverse buttons to make the vehicle move
towards and backwards. For left and right turning, press the left and
right buttons respectively. PLEASE NOTE. the vehicle will turn only
when It is moving towards or backwards. ALSO NOTE, the operation
lights will turn on when the vehicle is in use (see diagram #5).
3. Adjust the fine tune steering lever located under the vehicle to keep it
moving straight (see diagram #6).
Diagram as
PLEASE NOTE:
a). When operating the controller, please do not touch the antenna.
As control distance and the speed will both be affected.
b). If you notice a reduction in speed and control, please begin recharging
per the instructions above, or if necessary replace batteries.
WARNING:
Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void me user's authority to operate the
equipment.
PLEASE NOTE:
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates. uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions. may cause harmful interference to radio communications.
However. there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit difierent from that to
which the receiver is needed
- Consult the dealer or an experienced radio/TV technician for help
This device complies with pan 15 of the FCC rules. Operation is subject to
the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference recieved, including interference
that may cause undesired operation of the device.
NOTE:
- Do not mix old and new batteries
- Do not mix alkaline, standard (carbon zinc), or rechargeable
(nickel—cadmium) batteries. 4
msmunrmn MAME/ll
walnut-mailman!"
Manufactured and dims-mu by
Planet Toys. 5mm, FL 34242
Marie in Chlnl
Colors and mane mly vary
Keep mum details for future reference
‘IMPORTANT - IF CHARGER LIGHT DIMS OR IF VEHICLE
OR MOTORCYCLE DOES NOT RESPOND PROPERLY,
PLEASE REPLACE CHARGER BATTERIES (3x AAA).
m‘NOTE: THE MANUFACTURER IS NOT RESPONSIBLE
FOR ANY RADIO OR TV INTERFERENCE CAUSED BY
UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT.
SUCH MODIFICATIONS COULD VOID THE USER'S
AUTHORITY TO OPERATE THE EQUIPMENT.
CONSUMER SERVICE
Please do not return to storel
For parts Information, or questions please call:
1-877-FUN-TOYS
REV. 10/4/02

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.3
Linearized                      : No
Creator                         : HP Digital Sending Device
Create Date                     : 0000:01:01 00:00:00
Author                          : 
Producer                        : HP Digital Sending Device
Title                           : 
Subject                         : 
Modify Date                     : 2002:10:10 11:51:34+08:00
Page Count                      : 2

EXIF Metadata provided by EXIF.tools