Platinum Access Systems PLJS181 RF Receiver User Manual JS 181

Platinum Access Systems Inc. RF Receiver JS 181

User Manual

JJ-JS-181 INSTRUCTION OF 4-CH HIGH MEMORY RECEIVER CHARACTERISTICS: small and nice, easy to install and operate. USAGE: we put connectors on PCB for you to connect wires and control home applicance, doors, bus etc. FREQUENCY: 433.92MHz (RX Only)COMMUNICATION MODE: ASK WORKING VOLTAGE: DC12V WORKING CURRENT: 9-180MA RATED LOAD:20A CHIP: PT4301LEARNING CODES AVAILABILITY: 250pcs RECEIVER OUTPUT: super heterodyne DISTANCE: 70M LED: It’s green when in normal working state; if receive same code it’ll be red. 1. Control mode: CONTINUOUS OUTPUT: press the button and the relay works, press again the relay stops working. MOMENTARY OUTPUT: press one button, the relay works; the relay stops working once you release the button.
2. Learning code: VIA LEARNING BUTTON ON PCB: keep pressing learning button for 10 seconds and LED will flash 8 times, which means the original codes are deleted. Short press it and release, LED will light for about 8 seconds(if there’s no signal input within 8 seconds the learning state will stop), if there’s signal input LED will be offt, which means the code has been learnt. You can only learn one code one time. You can learn 250 codes at most. 3. Clearing code: Long press the button on PCB for 5s, the LED flash 5times, codes cleared successfully 4. Change Bistable and Monostable: The skipped pin on PCB short circuit is Monostable, open circuit is Bistable This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Navigation menu