Polar Electro PT0122210010T Bluetooth dongle User Manual 15
Polar Electro Oy Bluetooth dongle 15
Manual
Bluetooth USB Adapter
Quick Start Guide
Setup for Windows 98SE/ME/2000/XP
1. Insert the accompanying CD and the setup menu should launch automatically.If the setup menu
does not launch automatically, use Windows Exploret to navigate to the appropriate CD-ROM
drive and run “setup”.
2. When the License Agreement screen is displayed,read the License Agreement,then click the
radio button to the left of “I accept”and then click the “Next”button.
3. During the installation,the system will try to detect your Bluetooth device,please plug in your
Bluetooth device and then click the “OK”button.
4. When the installation is completed,please click the “Yes”button to restart your system.
Removing the software from Windows 98SE/ME/2000/XP
Double-Click the “Add/Remove”icon in Control Panel,then choose “Bluetooth Stack for
Windows by Toshiba” then click on “Add/Remove”button to remove the software and driver.
Federal Communications Commission (FCC) Statement
15.21
You are cautioned that changes or modifications not expressly approved by the part responsible for
compliance could void the user’s authority to operate the equipment.
15.105(b)
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help.
Operation is subject to the following two conditions:
1) this device may not cause interference and
2) this device must accept any interference, including interference that may cause undesired
operation of the device.
FCC RF Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. End users must follow the specific operating instructions for satisfying RF exposure
compliance. This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.