Polygroup 1702 Remote Controller User Manual TG76P4812L02 1
Polygroup Limited(Macao Commercial Offshore) Remote Controller TG76P4812L02 1
manual
Manual
Remote Controller
Model Number: RC5A1
MADE IN CHINA
2
3
4
5
1
6
Fig 1
Fig 2
USER INSTRUCTIONS FOR REMOTE CONTROLLER
1. This remote controller is used to operate Grow & Stow christmas tree product.
2. Remove the battery lid at the back of remote control, install two AAA/UM4/LR03 batteries
(not included) as indicated inside the battery compartment. Make sure to match the (+) and (-) ends of
the batteries. (see Fig 2).
3. Press light mode button to navigate the light functions.
4. Press the UP button on Remote Control Hand Set to activate the tree Grow motion.
5. Press the DOWN button on Remote Control Hand Set to activate the tree Stow motion.
6
3
4
5
Key Description Qty
1 Remote Control handset 1
2 Remote LED indicator
3 Remote light functions button
4 Remote grow (Up and Pause) button
5 Remote stow (Down and Pause) button
6 Remote battery compartment and lid
FCC Information and Copyright
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1)This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
28
IC warning
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) This device may not cause
interference, and (2) This device must accept any interference, including interference
that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si
le brouillage est susceptible d'en compromettre le fonctionnement
changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.