Pred Technologies USA REACTORS TOKK Reactors Wireless Stereo Speakers User Manual Reactors Quick User Guide
Pred Technologies USA, Inc. TOKK Reactors Wireless Stereo Speakers Reactors Quick User Guide
User Manual
Quick User Guide
Model #：TOKK REACTORS
Main Features
Fashion and cute Magnets Adsorbed
Stereo sound
Bluetooth remote shutter
Smart Siri Assistant
Hands-free call
Lanyard and jack to attach to device
Rechargeable Battery
Easy operation
1. Power On/Off
2. Remote Shutter
3. USB port
4. Speaker
5. Lanyard hole
6. LED Light
7. MIC
Button Definition
Play/Pause/Answer Call (1)
● Press and hold the Power button to power On/Off.
● Press button (1) to pause when music is playing, press again to replay.
● Press button (1) to answer incoming calls when the device is paired
with a phone, press again to end call.
Pairing
● Press and hold the power button on both REACTORS a Blue LED light
will flashing on the left speaker; and a Green LED light will be flashing
on the right speaker.
● Note: If cannot automatically paired as stereo set, power on both
REACTORS at same time, and press any one of button (2) TWO times
to pair as one set stereo;
Remote Camera (2)
● Open your mobile phone’s camera, press button (2) to take pictures.
● To access Siri or Google, press and hold button (2) to activate voice
assistant feature, wait for sound and ask anything.
● When under music playing, press button (2) to increase volume.
Working LED Light
● Fast Blue LED flashing shows Bluetooth searching Mode
● Slow Blue LED flashing shows Bluetooth connecting.
● Successful paired as stereo set, a Blue LED light flashing on the left
speaker and a Green LED light flashing on the right speaker.
Charging LED light
● Steady Red LED light while the device is charging
● Red LED extinguished when fully charged
Specifications
Rated Power PO=2W
Frequency Response 180HZ-16KHZ
Distortion Factor THD<1%
Signal to Noise Ratio S/N≥90DB
Separation ≥55DB
Speaker 4Ω 2W
Battery 3.7V/800mAh polymer Li battery
Playing time about 10hrs
Charing time 2hrs
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
To assure continued compliance, any changes or modifications not expressly
approved by the party.
Responsible for compliance could void the user’s authority to operate this
equipment. (Example- use only shielded interface cables when connecting to
computer or peripheral devices).
This equipment complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that
may cause undesired operation.
RF warning statement:
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.