Primax Electronics CA1TX Wireless Power Charger (A4WP) User Manual

Primax Electronics Ltd Wireless Power Charger (A4WP)

a href="https://usermanual.wiki/Primax-Electronics" itemprop="url"> Primax Electronics >

User Manual.pdf

Introduction     As required by FCC KDB Publication 680106 D01 wireless charging devices require RF exposure evaluation. For A4WP charging devices it is typically necessary to have FCC oversight through the pre-Approval Guidance (PAG) procedures (formerly referenced to as Permit But Ask or PBA)      Intel has performed the evaluation for the charging coil and associated electronics at maximum charging current of    0.68 Amps (rms) and has followed FCC's Pre-Approval Guidance procedures. FCC the approved the RF exposure evaluation of this combination of coil and maximum charging current and the approval for a 20cm separation distance can be leveraged to support this specific device's characteristics and form factor and is only applicable to identical devices as defined in 47 CFR 2.908.  During the certification process for the Bluetooth transceiver (and possibly Part18 wireless charging transmitter) the Certification body should request a copy of the KDB enquiry. The enquiry shall ne filed as confidential document in accordance with FCC procedures and should be accompanied by a copy of this document and user information document containing the required information.  This KDB enquiry still requires that the final device be tested for compliance with the requirements of Part 18 for Consumer ISM devices and FCC Part 15.247 for the Bluetooth transmitter.  If the wireless charging feature is integrated into another device the FCC rules and approvals requirements applicable to the other device need to be followed and a separate KDB enquiry shall be submitted to the FCC to confirm the appropriate RF exposure evaluation distance and device configurations.
No. 669, Ruey Kuang Road Neihu Taipei, Taiwan, R.O.C. Tel: 883-2-2798-9008 Fax: 886-2-8798-1565      A1TX User Manual Radiation Exposure Statement:  To comply with RF exposure requirements the charging mat must be used on a table top or similar and provide a minimum separation distance of 20cm from the charging surface to users.   The information required for devices that have been approval using FCC's certification procedures for Part 18 and for the Bluetootj transceiver will need the following information (refer to FCC CFR Title 47 Part 18.213,:  Model: A1TX / Wireless Power Charger (A4WP)  This device complies with Part 15 and Part 18 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received,   including interference that may cause undesired operation.  Modifications mode to this device, unless expressly approved by PRIMAX ELECTRONICS LTD.. may void the   user's rights to operate this equipment.
Download:
Mirror Download [FCC.gov]
Document ID2808104
Application IDe+Jxrx5OgTF3ENZILsPhAQ==
Document DescriptionUser Manual.pdf
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize39.31kB (491435 bits)
Date Submitted2015-11-10 00:00:00
Date Available2016-05-08 00:00:00
Creation Date2015-11-06 06:17:23
Document Lastmod2015-11-09 13:50:32
Document TitleUser Manual.pdf
Document Author: swliao
FCC ID Filing: EMJCA1TX

Navigation menu