Primax Electronics MMOBTEPUL Pineapple BT Laser Mouse User Manual pineapple BT laser manual
Primax Electronics Ltd Pineapple BT Laser Mouse pineapple BT laser manual
User Manual
Pineapple BT Laser Mouse USER MANUAL Model: MOBTEPUL
Introduction
Congratulations on your purchase of the Bluetooth mouse.
Features
• Bluetooth® 2.0 interface (compliant with Bluetooth 1.0)
• Advanced tilt wheel for scrolling vertically and horizontally
• Avago™ laser sensor with resolution up to 1600 dpi
Pineapple BT Laser Mouse USER MANUAL Model: MOBTEPUL
Installing your mouse
Installing the batteries
To install the batteries:
1 Pry the battery cover open.
2 Insert two AAA batteries into the battery compartment.
Make sure that the + and – symbols on the batteries
match the + and – symbols in the battery compartment.
3 Replace the battery cover.
Installing your mouse
To install your mouse:
1 Turn on your computer and make sure that your Bluetooth device is set to search mode.
2 Slide your mouse’s power switch to the “ON” position. The switch is located on the bottom of your mouse.
3 Press and hold the pairing button on the bottom of your mouse until the LED indicator flashes blue.
4 Your computer automatically detects your mouse and installs the appropriate driver.
Using the mouse
Note: Avoid using your mouse on a reflective, transparent, metallic, or complex-patterned surface.
To use your mouse:
1 Press the left or right mouse button to perform standard left and right mouse clicks.
2 Move the scroll wheel to move the screen image up, down, left, or right.
Maintaining
To clean your mouse, wipe the surface and the optical sensor with a soft, lint-free cloth slightly moistened with water.
Troubleshooting
• Make sure that you have paired your mouse with your computer.
• Make sure that your operating system is compatible with your mouse.
• Make sure that the + and – symbols on the batteries match the + and – symbols in the battery
compartment.
• Make sure that you use your mouse on a clean, flat, non-slippery surface. Avoid reflective, transparent, metallic,
or complex-patterned surfaces.
Pineapple BT Laser Mouse USER MANUAL Model: MOBTEPUL
Legal notices
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help.
CAUTION:
Any changes of modifications not expressly approved by the grantee of this device could void the user’s authority to
operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
End users must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must
not be co-located or operating in conjunction with any other antenna or transmitter.