18346 1 Little Giant 113093 Install Manual 998265 Dcr 08 170 User
User Manual: Pump 18346 1 Little Giant 113093 Install Manual
Open the PDF directly: View PDF 
.
Page Count: 1
TYPICAL INSTALLATION (FIGURE 1):
Verify all parts with basin and cover assemblies are received intact.
1. Remove bolts and washers in cover and set aside.
2. Remove gasket material from hardware kit and place material
around circumference of basin inside of bolt circle.
3. Install the discharge pipe in the discharge of the pump.
4. Install float switch 4" above discharge of pump with a 3-1/2"
tether length. Float switch should be installed in a manner that
will not allow it to contact the pump or side of basin during
operation. Refer to float switch instruction manual for alterna-
tive settings. Place the pump in the basin.
5. To install the cover, pull the pump and float cords through the
smallest hole in the cover. Place the cover on the basin, mak-
ing sure the discharge pipe is through the proper hole in the
cover (holes are labeled on bottom of cover). Secure the lid
to the basin, using the bolts and washers provided. Place the
larger square-cut O-ring on discharge pipe with beveled edge
down. Install flange and tighten bolts. Place the remaining O-
ring in the bottom of the vent flange with beveled edge down.
Install flange and tighten bolts.
6. Pull the slack out of the cords and install them through the
grommet 1"–2" above the cover. Press the grommet in the hole
in the cover.
7. Install a vent pipe by threading it on the vent flange. Make sure
the flange bolts are tight.
LITTLE GIANT
SEWAGE ACCESSORIES
& INSTRUCTIONS FOR
TYPICAL INSTALLATION
Figure 1
Typical Installation
REPLACEMENT PARTS LIST
ITEM P/N DESCRIPTION QTY.
1 113095 BASIN, 20" x 30" 1
1 113093 BASIN, 24" x 24" 1
2 113180 COVER ASSEMBLY, 2V2D 1
2 113181 COVER ASSEMBLY, 2V3D 1
2 113182 COVER ASSEMBLY, 3V2D 1
2 11318300 COVER ASSEMBLY, 3V3D 1
3 113215 FLANGE, 2" VENT PIPE 1
3 113202 FLANGE, 3" VENT PIPE 1
4 113214 FLANGE, 2" DISCHARGE PIPE 1
4 113216 FLANGE, 3" DISCHARGE PIPE 1
5 925014 GROMMET, 2-HOLE 1
* 11317100 COVER ASSEMBLY HARDWARE KIT 1
Franklin Electric Co., Inc.
P. O. Box 12010
Oklahoma City, OK 73157-2010
405.947.2511 • Fax: 405.947.8720
www.LittleGiantPump.com
CustomerService-WTS@fele.com
For parts or repair, please contact . . . . . . . . . . . . . . . . . . . .1-888-572-9933
For technical assistance, please contact . . . . . . . . . . . . . . .1-888-956-0000
www.LittleGiantPump.com
CustomerService-WTS@fele.com
Form 998265 - 1/13/2009
© 2009 Franklin Electric Co., Inc.
Little Giant® is a registered trademark of Franklin Electric Co., Inc.
ASSEMBLY INSTRUCTIONS FOR
BC2030CS-LG BASIN/COVER ASSEMBLY
BC2424CS-LG BASIN/COVER ASSEMBLY
