RFRemotech RF1X Wireless Receiver to control Fire Works User Manual

RFRemotech Company Wireless Receiver to control Fire Works Users Manual

user manual

1 234567 810911 120.1 0.20.3 0.40.5 0.60.7 0.81.00.92.0 ALLSTARTSTEPERPAU SECONTINUESTOPLOCK/UNLOCK1 234567 810911 120.1 0.20.3 0.40.5 0.60.7 0.81.00.92.0 ALLSTARTSTEPERPAU SECONTINUESTOPLOCK/UNLOCK
Warning!!! Power:Firing Current:Test Current:Sizes:1x 6LR61 9V battery>750mA, Max.6A<1mAL62xH46xW38mm, antenna is retractile and can be folded.With Power/Low Power Indication, Firing Indication, RF SignalIndication, Overload Protection and Short Warning Indication etc..Power:Firing Current:Test Current:Sizes:Bright RedDim Red1- , retractile and can be folded.2- , states:.Firing. If the red LED keeps on all theway, it indicates the module shorts out..Sleeping. Once the module fires, 5minutes later, the module will go tosleeping mode to save power. PressSYNC button or shift the switch towake it up.3- . Used to synchronize transmitters or delete synchronizaton.4- , ON / OFF.5- for igniter connection. Red for anode, black for cathode.6- . The battery compartment contains 1x 6LR61 9V battery.AntennaLEDSYNC ButtonSwitchWiring TerminalsBattery Cover3-color. Igniter is connected and tested well..An matching RF signal is received, or the module is counting the firingsequence number. If the wiring terminals are connected igniter andthe battery is low, the LED will be Green Blinking..No igniter is connected..If the Wiring Terminals are not connected igniter and the battery islow, the LED will be Orange Blinking.GreenGreen BlinkingOrange (Red and Green LEDs are on in the same time)Orange BlinkingAntennaLEDSYNC ButtonSwitchWiring TerminalsBattery Cover3-colorParts:12 3456
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Navigation menu