RJE Technologies AIA100 Pool alarm system for aquatic centers to alert first responders. User Manual RJE
RJE Technologies, Inc. Pool alarm system for aquatic centers to alert first responders. RJE
Users Manual
BY RJE TECHNOLOGIES, INC.
Users Manual
RJE TECHNOLOGIES, INC.
15375 Barranca Parkway I-112 • Irvine, CA 92618 • Phone 949-943-3349
Email: info@rjetechnologies.com • Website: www.rjetechnologies.com
Aquatic Incident Alert Users Manual
Components:
Needed for installation:
• Power Drill • Screwdriver • Level
AIAI 100 Base with AC adapter
AIAI 150 Receiver with adapter
AIAI 200 Repeater with adapter
Alarm
Power
Battery
BY RJE TECHNOLOGIES, INC.
Repeater
BY RJE TECHNOLOGIES, INC.
Alarm
Power Battery
BY RJE TECHNOLOGIES, INC.
Reset
Screw
antenna
into side
of base
Suggested installation sites
The AIAI 100 Base must see the pool and is suitable for outdoors instal-
lation. The base has a siren and will alarm when activated by SOS sensors.
Should be wall mounted 5 feet above ground level. It must be plugged
into an AC outlet.
The AIAI 150 Receiver has a siren and should be placed where first
responders can hear it. It must be plugged into a USB port or and AC outlet.
The AIAI 200 Repeater 200 Repeater can be wall mounted and should
be placed in a location to extend range of signal if needed. The Repeater
does not have a siren and is used strictly to extend the range to the
receiver. It must be plugged into an AC outlet.
Introduction
RJE Technologies, Inc Aquatic Incident Alert is a commercial pool alarm
system designed to alert responders when the life guard has entered the
water. SOS sensors are placed on the life guard’s tube and activated by a
water switch. The system is designed to work in large facilities and has
an optional repeater to extend range if necessary.
Installation
Each components has an antennae that must be screwed on. The Base and
Repeater come with hardware to wall mount 5 feet above ground level.
The receiver can sit on a desk or shelf and has a USB cord and power adapter.
Operation
Once the components are mounted and plugged in the system is ready
to use. SOS sensors on the life guards’ tube will activate the alarm when
they are in the water. The system will alarm at the Base and Receiver. To
stop the alarm, the SOS sensor must be wiped off and the reset button
on the Base is pushed to rearm the system. The alarm cannot be stopped
at the First Responder location Receiver. The Repeater does not alarm
nor can it stop the alarm.
The power light on the Base and Receiver will always be on when the
system is plugged in and the alarm light will flash when activated. The
battery indicator on the base and receiver will flash when the battery in
the SOS sensor is low.
Be sure to push the reset button on the Base after an alarm. This places the
system back into armed mode. SOS sensors must be dry to discontinue
the alarm.
Federal Communications Commission (FCC) Notice
Model: AIA100 (Aquatic Incident Alert)
FCC ID: T5P-AIA100
This device complies with Part 15 of FCC Rules. Operation is subject
to the following two conditions:
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by RJE Technologies,
Inc. could void the users authority to operate the equipment.
Email: info@rjetechnologies.com • Website: www.rjetechnologies.com
BY RJE TECHNOLOGIES, INC.