RMJ Group EBT-164B Bluetooth Speaker User Manual
RMJ Group International Bluetooth Speaker
User Manual
CHARGING THE SPEAKERS
USING AS DUAL STERO SPEAKERS
Charge the speakers before using
them for the first time.
Plug in the cable to the micro USB
port and charge for 1 hour
Connect the charging cable to
charging ports
Turn on both speakers by flipping
the Power Switch to the ‘ON’
position. Both of the speakers will
‘prompt’ when they are ready to
connect to each other.
Wait 3 seconds, the speakers will
automatically pair to each other and
one speaker will ‘prompt’ to indicate it
is paired with the second speaker.
From your smart phone or tablet,
find a list of nearby devices and
choose ‘SOUND DOME’, enter
‘0000’ if asked. The speaker will
‘prompt’ again when pairing is
completed.
Your speaker will work best if it is within 30ft of your smart device. You may experience sound
briefly cutting off if you are out of range or if your wireless connection is weak. If the speakers
are not paired with a device after 5 minutes, they will turn off automatically. Make sure Bluetooth
is enabled on your smart phone or tablet before starting the pairing process.
USING SPEAKER INDIVIDUALLY FOR DIFFERENT DEVICES
Turn on one speaker by flipping the
Power Switch to the ‘ON’ position.
The first speaker will ‘prompt’ when it
is ready to pair. Leave the second
speaker turned off. Pair one device
at a time to your multiple devices.
From your smart phone or tablet,
find a list of nearby devices and
choose ‘SOUND DOME’, enter
‘0000’ if asked. The speaker will
‘prompt’ again when pairing is
completed.
To pair the second speaker, repeat
steps 1 and 2 with your second
device. Ensure that you are far
enough away from the first speaker
and device to avoid a signal error.
The speakers can be paired to different devices. For example, you can use one speaker
with a smart phone and the other speaker with a tablet.
WARNING
Keep away from water and moisture.
FCC Warning
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
NOTE 1: Any changes or modifications to this unit
not expressly approved by the party responsible
for compliance could void the user's authority to
operate the equipment.
NOTE 2: The device has been evaluated to meet
general RF exposure requirement. The device can
be used in portable exposure condition without
restriction.
Keep away from heat sources. Do not
disassemble.
CONNECTION LOST?
● If pairing two speakers does not work, turn
off the speakers and repeat the steps again
‘Using speakers as a pair’.
● Make sure your speakers are within range of
your smart device.
● If you hear a long prompt, you need to recharge
your speakers. Connection may be lost due to
low battery.
● When charging your speakers, only use the
enclosed USB cable.
108 cm
140 cm
Please read the manual before using
the device.